ADAU1361BCPZ Analog Devices Inc, ADAU1361BCPZ Datasheet - Page 44

• Manufacturer Part Number: ADAU1361BCPZ
• Description: IC CODEC 24B PLL 32LFCSP
• Manufacturer: Analog Devices Inc
• Type: Audio Codecr

Specifications of ADAU1361BCPZ

• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 2
• Sigma Delta: No
• Voltage - Supply, Analog: 1.8 V ~ 3.6 V
• Voltage - Supply, Digital: 1.8 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 32-VFQFN, CSP Exposed Pad
• Audio Codec Type: Stereo
• No. Of Adcs: 2
• No. Of Dacs: 2
• No. Of Input Channels: 6
• No. Of Output Channels: 7
• Adc / Dac Resolution: 24bit
• Adcs / Dacs Signal To Noise Ratio: 101dB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ADAU1361
APPLICATIONS INFORMATION
POWER SUPPLY BYPASS CAPACITORS
Each analog and digital power supply pin should be bypassed to
its nearest appropriate ground pin with a single 100 nF capaci-
tor. The connections to each side of the capacitor should be as
short as possible, and the trace should stay on a single layer with
no vias. For maximum effectiveness, locate the capacitor equi-
distant from the power and ground pins or, when equidistant
placement is not possible, slightly closer to the power pin.
Thermal connections to the ground planes should be made
on the far side of the capacitor.
Each supply signal on the board should also be bypassed with a
single bulk capacitor (10 μF to 47 μF).
GSM NOISE FILTER
In mobile phone applications, excessive 217 Hz GSM noise on
the analog supply pins can degrade the audio quality. To avoid
this problem, it is recommended that an L-C filter be used in
series with the bypass capacitors for the AVDD pins. This filter
should consist of a 1.2 nH inductor and a 9.1 pF capacitor in
series between AVDD and ground, as shown in Figure 63.
Figure 62. Recommended Power Supply Bypass Capacitor Layout
Figure 63. GSM Filter on the Analog Supply Pins
AVDD
CAPACITOR
TO VDD
AVDD
1.2nH
VDD
0.1µF
0.1µF
10µF
+
TO GND
9.1pF
GND
Rev. C | Page 44 of 80
GROUNDING
A single ground plane should be used in the application layout.
Components in an analog signal path should be placed away
from digital signals.
EXPOSED PAD PCB DESIGN
The ADAU1361 has an exposed pad on the underside of the
LFCSP. This pad is used to couple the package to the PCB for
heat dissipation when using the outputs to drive earpiece or
headphone loads. When designing a board for the ADAU1361,
special consideration should be given to the following:
•
•
A copper layer equal in size to the exposed pad should be
on all layers of the board, from top to bottom, and should
connect somewhere to a dedicated copper board layer (see
Figure 64).
Vias should be placed to connect all layers of copper,
allowing for efficient heat and energy conductivity. For an
example, see Figure 65, which has nine vias arranged in a
3 inch × 3 inch grid in the pad area.
Figure 64. Exposed Pad Layout Example, Side View
Figure 65. Exposed Pad Layout Example, Top View
VIAS
COPPER SQUARES
TOP
GROUND
POWER
BOTTOM