VX2110-01T-3CR1 SMC Corporation, VX2110-01T-3CR1 Datasheet - Page 41

• Manufacturer Part Number: VX2110-01T-3CR1
• Description: Process Solenoid Valve, 2 port, direct operated, 1/8 port, NC, 110VAC, conduit
• Manufacturer: SMC Corporation
• Type: Direct Operatedr

Specifications of VX2110-01T-3CR1

• Brand/series: VX Series
• Number Of Ports: 2
• Primary Type: Solenoid Valve
• Size, Port: 1⁄8" NPTF
• Voltage, Coil: 110 VAC
• Enclosure: Equivalent to IP65

Back page 1
The following safety instructions are intended to prevent a hazardous situation
and/or equipment damage. These instructions indicate the level of potential hazard
by all safety practices, including labels of "Caution", "Warning" or "Danger". To
ensure safety, please observe ISO 4414
Note 1) ISO 4414: Pneumatic fluid power – General rules relating to systems
Note 2) JIS B 8370: General Rules for Pneumatic Equipment
1.
2.
3.
4.
Only trained personnel should operate machinery and equipment.
designs the system or decides its specifications.
Since the products specified here are used in various operating conditions, their compatibility with a
specific system must be based on specifications, post analysis and/or tests to meet a specific
requirement. The expected performance and safety assurance will be the responsibility of the person
who has determined the compatibility of the system. This person should continuously review the
suitability of all items specified, referring to the latest catalog information and taking into consideration
the possibility of equipment failure when configuring a system. Be particularly careful in determining
the compatibility with the fluid to be used.
The fluid can be dangerous if handled incorrectly. Assembly, handling or maintenance of the system
should be performed by trained and experienced operators.
Do not service machinery/equipment or attempt to remove components until
the safety is confirmed.
1. Inspection and maintenance of machinery/equipment should only be performed once measures to
2. When equipment is to be removed, confirm the safety processes mentioned above, release the fluid
3. Carefully restart the machinery, confirming that safety measures are being implemented.
1. Conditions and environments beyond the given specifications, or if product is used outdoors.
2. With fluids whose application causes concern due to the type of fluid or additives, etc.
3. An application which has the possibility of having a negative effect on people, property, and
Safety Instructions
Contact SMC if the product is to be used in any of the following conditions:
Series
The compatibility of equipment is the responsibility of the person who
prevent falling or runaway of the driven object have been confirmed. Measures to prevent danger
from a fluid should also be confirmed.
pressure and be certain there is no danger from fluid leakage or fluid remaining in the system.
therefore requires special safety analysis.
Caution
Warning
Danger
VX21/22/23
:
:
:
Operator error could result in injury or equipment damage.
Operator error could result in serious injury or loss of life.
In extreme conditions, there is a possible result of serious injury or loss of life.
Warning
Note 1)
, JIS B 8370
Note 2)
.