GLD150 Gold Performance Medical Switchers
150 Watt Single Output
85-264 Vac, 47-63 Hz single phase.
2.8 A line current maximum, at 90 Vac, 60 Hz with full rated load,
power factor .99 typical, .96 minimum. Input current harmonic
content meets the requirements of IEC1000-3-2.
150 W with convection cooling, 180 W with fan cooling.
Minimum 80% at full rated load with 230 Vac Input. Approximately
3% less at 115 Vac.
Outputs will remain within regulation limits for 25 ms minimum from
loss of ac input at full load, 10 ms before Power Fail indication.
Total regulation is the maximum deviation from the nominal voltage
for all steady state loading conditions. Peak ratings are for 60 s
maximum duration, 10% duty cycle.
Fully protected against short circuit and output overload. Short
circuit protection is cycling type power limit.
No minimum load required to maintain output specifications.
0.5% rms, 1% pk-pk, 20 MHz Bandwidth, differential mode.
Measured with noise probe directly across output terminals of the
Main Output - 500 µs typical response time for return to within
0.5% of final value for a 50% load step change, Di/Dt< 0.2 A µs.
Maximum voltage deviation is 3%.
Provided as a standard feature on all models.
Built in on all models.
Internal ac fuses provided on both lines on all units.
Output Voltage is adjustable +/- 5% with user adjustable potentiometer.
0.03% / °C typical on all outputs.
Less than 2% overshoot at turn-on under all conditions, less than
1% overshoot at turn-off under all conditions.
Inhibit signal is pulled to the V1 output common to reduce average
output voltage to less than 5% of nominal.
Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033
800-235-5929 • 805-486-4565 • FAX 805-487-8911 • www.condorpower.com
• Compact 4.5” x 7” x 1.7” size
• Power factor corrected to IEC 1000-3-2 Class A
• Less than 300 µA leakage
• EMI compliance to CISPR11, FCC Class B
• Power fail and remote sense standard
• Medical Approved to UL2601-1, IEC601-1/60601-1
and CSA-C22.2 No. 601.1
• 2 year warranty
marked to LVD
All models include built-in EMI filtering to meet the EMC require-
ments of IEC601-1. Unless otherwise stated, all tests are done
at full load and 115 and 230 Vac input.
EN55011, Class B; FCC Class B
EN61000-4-2, 6 kV contact 8 kV air
RF Field Susceptibility
Fast Transients / Bursts
EN61000-4-4, 2 kV, 5 kHz
EN61000-4-5, 1 kV diff., 2 kV com.
Conducted RF Susceptibility EN61000-4-6, 3V
Voltage Sags & Surges
Inrush 240 Vac is less than 37 A, averaged over the first ac half-
cycle under cold start conditions. Limiting provided by internal
An additional 12 Vdc, 250 mA output suitable for powering a dc
fan is included in all models. The fan output is both current limited
and thermally protected.
Provided as a standard feature. Designed to protect unit from
prolonged over temperature.
TTL / CMOS compatible output goes low (<0.5 V) 8 ms before
output voltage drops more than 4% below nominal voltage upon
loss of ac power.
TTL / CMOS compatible output goes high more than 100 ms
after V1 reaches regulation and should assure that sufficient
energy is stored in the input section to provide normal power
All models are Certified to be in compliance with the
applicable requirements of UL2601-1, CSA-C22.2 No. 601.1,
70 µA, 132 Vac @ 60 Hz normal conditions. Single fault condi-
tions, 130 µA, 254 Vac @ 50 Hz.
Design Verification Documents
The “Gold” series has undergone rigorous review and design
analysis. The following product documentation is available upon
1. MTBF study
2. DVT Data
3. EMC / Susceptibility test results