WD30-AT001 Omron, WD30-AT001 Datasheet - Page 76

• Manufacturer Part Number: WD30-AT001
• Description: REMOTE WIRELESS ANTENNA'S DNET
• Manufacturer: Omron

Specifications of WD30-AT001

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: WD30AT001

64
4-2-2
NNODE switch (DeviceNet
node address setting
switch)
DeviceNet setting switch
(SW1)
DeviceNet Wireless Slave Station Specifications
Settings
Maintaining/
Clearing output
when there is a
DeviceNet slave
communication
error
Set the DeviceNet interface node address here. Set the switches before turn-
ing on the power supply. Only the setting values detected immediately after
the power supply has been turned on are enabled. Changes to switch settings
after the power supply has been turned on are ignored.
Set the DeviceNet interface communication speed, relay station, and mea-
sures for when communication errors occur.
"Maintain/Clear output when communication errors occur" is for setting
whether to maintain or clear the ON output when a wireless network error
occurs and while communication continues in the DeviceNet network that the
wireless slave station is connected to. (Although communication continues in
the wireless network when an error occurs in the DeviceNet network, the ON
input to the wireless master station at that time becomes "Maintain".)
Set the switches before turning on the power supply. Only the setting values
detected immediately after the power supply has been turned on are enabled.
Changes to switch settings after the power supply has been turned on are
ignored.
Applications that require the maintaining of output when a DeviceNet slave communication error
occurs (if ON must be maintained when an error is occurred) cannot be used.
X10
SW1
ON
No.
1
2
3
4
125k
250k
500k
-
1 2
N NODE
Baud rate
• DeviceNet communication rate settings
3 4
Contents
Communication
speed selection
Relay station/No relay station
selection
Maintain/Clear output when
communication errors occur
X1
OFF
ON
OFF
ON
MODE1
1
DIP-SW status
MODE1
MODE2
OFF
OFF
ON
ON
MODE2
2
Length of main line: 500m
Length of main line: 250m
Length of main line: 100m
Settings prohibited, no
communication
Remarks
Section 4-2