CTSR 0.6-TP LEM USA Inc, CTSR 0.6-TP Datasheet - Page 9

• Manufacturer Part Number: CTSR 0.6-TP
• Description: TRANSDUCER CURRENT 0.6A
• Manufacturer: LEM USA Inc
• Series: CTSRr

Specifications of CTSR 0.6-TP

• Current - Sensing: -
• Accuracy: ±1.5%
• Sensitivity: -
• Current - Supply: 21.6mA
• Sensor Type: Flux Gate
• Voltage - Supply: 4.75 V ~ 5.25 V
• Output: -
• Frequency: 9.5kHz
• Response Time: 30µs, 30µs
• Polarization: Bidirectional, Unidirectional
• Operating Temperature: -40°C ~ 105°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 398-1111

PCB Footprint CTSR series
Assembly on PCB
The two retention pins inserted into the case of the transducer are electrically isolated by the housing. Because one of them is
close to the secondary connector, it is recommended to connect both to the secondary side GND or +Vc.
Consequently any primary conductor must be placed in the PCB at the requested isolation distance regarding these secondary
sides (see also paragraph “Isolation around the CTSR transducer housing”).
Safety
This transducer must be used in limited-energy secondary circuits according to IEC 61010-1.
This transducer must be used in electric/electronic equipment with respect to applicable standards and safety requirements in
accordance with the manufacturer’s operating instructions.
Caution, risk of electrical shock.
When operating the transducer, certain parts of the module can carry hazardous voltage (e.g. primary bus bar, power supply).
Ignoring this warning can lead to injury and/or cause serious damage.
This transducer is a build-in device, whose conducting parts must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
22June2011 /Version 2
• Recommended PCB hole diameter
• Maximum PCB thickness
• Wave soldering profile
No clean process only
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
1.2 mm for secondary pin
2 mm for retention pin
2.4 mm
maximum 260 °C, 10 s
CTSR series
www.lem.com
Page 9/10