ATtiny26 Atmel Corporation, ATtiny26 Datasheet - Page 11

• Manufacturer Part Number: ATtiny26
• Manufacturer: Atmel Corporation

Specifications of ATtiny26

• Flash (kbytes): 2 Kbytes
• Pin Count: 20
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 16
• Ext Interrupts: 11
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.12
• Eeprom (bytes): 128
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 3
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

Stack Pointer – SP
Program and Data
Addressing Modes
Register Direct, Single
Register Rd
Register Direct, Two
Registers Rd and Rr
1477K–AVR–08/10
The ATtiny26(L) Stack Pointer is implemented as an 8-bit register in the I/O space location $3D
($5D). As the ATtiny26(L) data memory has 224 ($E0) locations, eight bits are used.
The Stack Pointer points to the data SRAM stack area where the Subroutine and Interrupt
Stacks are located. This Stack space in the data SRAM must be defined by the program before
any subroutine calls are executed or interrupts are enabled. The Stack Pointer must be set to
point above $60. The Stack Pointer is decremented by one when data is pushed onto the Stack
with the PUSH instruction, and it is decremented by two when an address is pushed onto the
Stack with subroutine calls and interrupts. The Stack Pointer is incremented by one when data is
popped from the Stack with the POP instruction, and it is incremented by two when an address
is popped from the Stack with return from subroutine RET or return from interrupt RETI.
The ATtiny26(L) AVR Enhanced RISC microcontroller supports powerful and efficient address-
ing modes for access to the Flash program memory, SRAM, Register File, and I/O Data
memory. This section describes the different addressing modes supported by the AVR architec-
ture. In the figures, OP means the operation code part of the instruction word. To simplify, not all
figures show the exact location of the addressing bits.
Figure 5. Direct Single Register Addressing
The operand is contained in register d (Rd).
Figure 6. Direct Register Addressing, Two Registers
Bit
$3D ($5D)
Read/Write
Initial Value
R/W
SP7
7
0
SP6
R/W
6
0
SP5
R/W
5
0
R/W
SP4
4
0
R/W
SP3
3
0
SP2
R/W
2
0
SP1
R/W
1
0
SP0
R/W
0
0
SP
11