ATxmega32A4U Atmel Corporation, ATxmega32A4U Datasheet - Page 147

• Manufacturer Part Number: ATxmega32A4U
• Manufacturer: Atmel Corporation

Specifications of ATxmega32A4U

• Flash (kbytes): 32 Kbytes
• Pin Count: 44
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 7
• Twi (i2c): 2
• Uart: 5
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 1024
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 16
• Pwm Channels: 16
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

13.9
13.10 Clock and Event Output
8331A–AVR–07/11
Slew Rate Control
Figure 13-10. Port override signals and related logic.
Slew rate control can be enabled for all I/O pins individually. Enabling the slew rate limiter will
typically increase the rise/fall time by 50% to 150%, depending on operating conditions and load.
For information about the characteristics of the slew rate limiter, please refer to the device
datasheet.
It is possible to output the peripheral clock and event channel 0 events to a pin. This can be
used to clock, control, and synchronize external functions and hardware to internal device tim-
ing. The output port pin is selectable. If an event occurs, it remains visible on the port pin as long
as the event lasts; normally one peripheral clock cycle.
PINnCTRL
D
D
D
Q
OUTn
DIRn
INn
R
R
R
R
Synchronizer
Analog Input/Output
Q
Q
Q
D
Digital Input Pin
Q
OUT Override Value
OUT Override Enable
R
DIR Override Value
DIR Override Enable
D
Pull Enable
Pull Keep
Pull Direction
Digital Input Disable (DID)
Wired AND/OR
Slew Rate Limit
Inverted I/O
DID Override Value
DID Override Enable
Atmel AVR XMEGA AU
Pxn
147