SAM7S32 Atmel Corporation, SAM7S32 Datasheet - Page 58

• Manufacturer Part Number: SAM7S32
• Manufacturer: Atmel Corporation

Specifications of SAM7S32

• Flash (kbytes): 32 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 21
• Ext Interrupts: 21
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 2
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Programmer’s Model
2.6.4
2-12
Accessing high registers in Thumb state
Registers r0–r7 are known as the low registers. Registers r8–r15 are known as the high
registers.
In Thumb state, the high registers, r8–r15, are not part of the standard register set. The
assembly language programmer has limited access to them, but can use them for fast
temporary storage.
You can use special variants of the MOV instruction to transfer a value from a low
register, in the range r0–r7, to a high register, and from a high register to a low register.
The CMP instruction allows you to compare high register values with low register
values. The ADD instruction enables you to add high register values to low register
values. For more details, please refer to the ARM Architecture Reference Manual.
Note
Copyright © 1994-2001. All rights reserved.
ARM DDI 0029G