SAM9XE512 Atmel Corporation, SAM9XE512 Datasheet - Page 188

• Manufacturer Part Number: SAM9XE512
• Manufacturer: Atmel Corporation

Specifications of SAM9XE512

• Flash (kbytes): 512 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Power Management
12-4
MMU RAMs
The RAM used to implement the MMU can be safely powered down if the MMU has
been disabled (using CP15 control register c1) and it contains no valid entries.While the
MMU is disabled, only explicit CP15 operations can cause the MMU RAM to be
accessed (c8 TLB maintenance operations, and c15 MMU test/debug operations).
These instructions must not be executed while the MMU RAM is powered down.The
MMU RAM must be powered up prior to re-enabling the MMU.
Copyright © 2001-2003 ARM Limited. All rights reserved.
ARM DDI0198D