1-794511-1 TE Connectivity, 1-794511-1 Datasheet - Page 5

• Manufacturer Part Number: 1-794511-1
• Manufacturer: TE Connectivity

Specifications of 1-794511-1

• Product Type: Connector
• Connector Line: AMP-DUAC
• Connector Type: Header
• Pcb Mounting Orientation: Right Angle
• Pcb Mount Retention: With
• Flange: Without
• Voltage (vac): 600
• Current Rating (a): 9
• Solder Tail Contact Plating: Tin over Nickel
• Number Of Signal Positions: 12
• Pcb Mount Retention Type: Boardlock(s)
• Positions Unloaded: None
• Centerline (mm [in]): 4.20 [0.165]
• Mount Type: Printed Circuit Board
• Contact Type: Pin
• Contact Plating, Mating Area, Material: Tin
• Contact Material (signal): Copper Alloy
• Solder Process Drain Hole: Without
• Connector Style: Plug
• Ul Flammability Rating: UL 94V-2
• Housing Color: Natural
• Housing Material: Nylon
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• High Temperature Header: No

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall each consist of a minimum of 5 samples.
Test groups 1 and 2 shall each consist of mated pairs of AMP-DUAC headers and the proper
AMP-DUAC socket connector (e.g. 106527 series receptacle housing and 106528 or 106529
series contacts) unless otherwise required by the test procedure. Test group 1 shall be terminated
to the maximum wire size. Samples for test groups 1 and 2 shall be mounted on printed circuit
board PN 60-469228-1. Samples for test group 3 shall be unmounted and unmated.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1699
5 of 6