MAX9693 Maxim, MAX9693 Datasheet - Page 8

• Manufacturer Part Number: MAX9693
• Description: The MAX9691/MAX9692/MAX9693 are ultra-fast ECL comparators capable of very short propagation delays
• Manufacturer: Maxim

Single/Dual, Ultra-Fast, ECL-Output
Comparators with Latch Enable
V
V
V
t
t
t
t
PROCESS: BiCMOS
8
pd+
pd-
LE(+)
LE(-)
OS
IN
OD
_______________________________________________________________________________________
Input Offset Voltage. The voltage required
Input Voltage Pulse Amplitude
Input Voltage Overdrive
Input to Output High Delay. The propagation
Input to Output Low Delay. The propagation
Latch-Enable to Output High Delay. The prop-
Latch-Enable to Output Low Delay. The prop-
between the input terminals to obtain 0V dif-
ferential at the output.
delay measured from the time the input signal
crosses the input offset voltage to the 50%
point of an output low-to-high transition.
delay measured from the time the input signal
crosses the input offset voltage to the 50%
point of an output high-to-low transition.
agation delay measured from the 50% point of
the latch-enable signal low-to-high transition
to the 50% point of an output low-to-high tran-
sition.
agation delay measured from the 50% point of
the latch-enable signal low-to-high transition
to the 50% point of an output high-to-low tran-
sition.
Chip Information
Definition of Terms
t
t
t
∆
P
t
Note: Devices are also available in lead(Pb)-free/RoHS-compli-
ant packages. Specify lead-free by adding a “+” after the part
number.
pw
s
h
pdm
MAX9692EUB
MAX9692ESE
MAX9692EPE
MAX9693ESE
MAX9693EEE
MAX9693EPE
pd
DSP
Ordering Information (continued)
(LE)
PART
Latch-Enable Pulse Width. The minimum time
Setup Time. The minimum time before the
Hold Time. The minimum time after the nega-
Propagation Delay Skew. The difference in
Propagation Delay Dispersion. The change in
Propagation Delay Match (MAX9693 only).
the latch-enable signal must be high to acquire
and hold an input signal.
negative transition of the latch-enable pulse
that an input signal must be present to be ac-
quired and held at the outputs.
tive transition of the latch-enable signal that
an input signal must remain unchanged to be
acquired and held at the output.
propagation delay between the Q and Q out-
puts crossing each other in both directions.
propagation delay as a result of the overdrive
of the input signal varying.
The difference in propagation delay between
two separate channels.
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
RANGE
TEMP
PIN-PACKAGE
10 µMAX
16 Narrow SO
16 PDIP
16 Narrow SO
16 QSOP
16 PDIP