NCSL219A-H1 Nichia, NCSL219A-H1 Datasheet - Page 6

• Manufacturer Part Number: NCSL219A-H1
• Manufacturer: Nichia

Specifications of NCSL219A-H1

• Size Lxwxh (mm): 3.5x3.5x2.0
• Lumi-nous Inten-sity Typ(cd): 29
• Lumi-nous Flux Typ(lm)): 83.0
• Ra Min: 85
• Forward Voltage Vf(v) Typ: 3.30
• Forward Voltage Vf(v) Max: 3.80
• Directivity (degree): 120
• If (ma): 350
• Mounting Style: Through Hole

SOLDERING
• Recommended Reflow Soldering Condition(Lead-free Solder)
• Recommended Soldering Pad Pattern
* This LED is designed to be reflow soldered on to a PCB. If dip soldered or hand soldered,
* Reflow soldering must not be performed more than twice.
* Avoid rapid cooling. Ramp down the temperature gradually from the peak temperature.
* Nitrogen reflow soldering is recommended. Air flow soldering conditions can cause optical degradation,
* Since the silicone used in the encapsulating resin is soft, do not press on the encapsulant resin.
* Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
* The Die Heat Sink should be soldered to customer PCB.
* When soldering, do not apply stress to the LED while the LED is hot.
Nichia cannot guarantee its reliability.
caused by heat and/or atmosphere.
Pressure can cause nicks, chip-outs, encapsulant delamination and deformation, and bump breaks, decreasing reliability.
When using automatic pick and place machine, use a pick up nozzle which does not directly apply stress
to the encapsulation of the LEDs.
Recommended conditions:
a hot plate should be used.
It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
If it is difficult or impossible, use high heat-dissipating adhesive.
1 to 5°C per sec
0.4
It is recommended to use a pick up nozzle designed for the LEDs. (See Figure below.)
* Avoid direct contact to the resin lens
Pre-heat
180 to 200°C
120sec Max
with the picking up nozzle.
Failure to comply might result in catastrophic failure
of the LEDs due to bump damage or breakage.
0.5
3.8
3
0.5
60sec Max
Above 220°C
1.3
4.1
(単位 Unit: mm)
260°C Max
10sec Max
(単位 Unit: mm)
5