CRG04 TOSHIBA Semiconductor CORPORATION, CRG04 Datasheet - Page 2

• Manufacturer Part Number: CRG04
• Description: Toshiba Rectifier Silicon Diffused Type
• Manufacturer: TOSHIBA Semiconductor CORPORATION

Marking
Standard Soldering Pad
Handling Precaution
The absolute maximum ratings are rated values and must not be exceeded during operation, even for an instant. The
following are the general derating methods that we recommend when you design a circuit with a device.
V
I
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180. Therefore,
this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at Tj below 120℃ under the worst load and heat radiation conditions.
Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When using
a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
Please refer to the Rectifiers databook for further information.
F(AV)
RRM
1.2
Abbreviation Code
: We recommend that the worst case current be no greater than 80% of the maximum rating of I
: We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the maximum
rating of V
V
at low temperature.
adequate heat design. If you can’t design a circuit with excellent heat radiation, set the margin by using an
allowable Ta max-I
RRM
1.2
G4
has a temperature coefficient of 0.1%/℃. Take this temperature coefficient into account designing a device
RRM
2.8
for a DC circuit and be no greater than 50% of that of V
F (AV)
Part No.
CRG04
curve.
Unit: mm
2
RRM
for an AC circuit.
F(AV)
2008-02-01
CRG04
. Carry out