OPA2607 Burr-Brown, OPA2607 Datasheet

no-image

OPA2607

Manufacturer Part Number
OPA2607
Description
Dual / High Output / Current-Feedback OPERATIONAL AMPLIFIER
Manufacturer
Burr-Brown
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
OPA2607H
Manufacturer:
BB/TI
Quantity:
12 500
Part Number:
OPA2607H
Manufacturer:
TI/德州δ»ͺ器
Quantity:
20 000
Part Number:
OPA2607H/2K5
Manufacturer:
BB/TI
Quantity:
20 000
Part Number:
OPA2607IDGKR
0
Part Number:
OPA2607N
Manufacturer:
BB
Quantity:
20 000
Part Number:
OPA2607QDGKRQ1
0
Part Number:
OPA2607U
Manufacturer:
BB
Quantity:
5 510
Part Number:
OPA2607U
Manufacturer:
FAI
Quantity:
5 510
Part Number:
OPA2607U
Manufacturer:
BB
Quantity:
20 000
SBOS128
4.8Vp-p
For most current data sheet and other product
FEATURES
APPLICATIONS
©
2000 Burr-Brown Corporation
Low Turns Ratio ADSL Upstream Driver
information, visit www.burr-brown.com
WIDEBAND 12V OPERATION: 25MHz (G = +8)
UNITY GAIN STABLE: 35MHz (G = +1)
HIGH OUTPUT CURRENT: 250mA
OUTPUT VOLTAGE SWING: 10.5V (V
HIGH SLEW RATE: 600V/ s
LOW SUPPLY CURRENT: 8mA/channel
FLEXIBLE POWER CONTROL (SO-14)
xDSL LINE DRIVER
LOW-NOISE ADSL RECEIVER
LOW-COST VIDEO DA
LOW-COST UPGRADE TO LT1207/AD812
6V TO 16V SUPPLY RANGE
International Airport Industrial Park • Mailing Address: PO Box 11400, Tucson, AZ 85734 • Street Address: 6730 S. Tucson Blvd., Tucson, AZ 85706 • Tel: (520) 746-1111
Twx: 910-952-1111 • Internet: http://www.burr-brown.com/ • Cable: BBRCORP • Telex: 066-6491 • FAX: (520) 889-1510 • Immediate Product Info: (800) 548-6132
100nF
348
OPA2607
OPA2607
POWER PACKAGING
1.21k
1.21k
1/2
1/2
+12V
–12V
®
OPERATIONAL AMPLIFIER
38Vp-p
78.7
78.7
TM
Dual, High Output, Current-Feedback
1:0.8
100
S
= 12V)
15Vp-p
PDS-1615A
1
DESCRIPTION
The OPA2607 provides a high output voltage swing and low
distortion required for low turns ratio ADSL upstream driver
applications. Operating on a 12V supply, the OPA2607 con-
sumes a low 8.0mA/channel quiescent current to deliver a very
high 250mA peak output current. Guaranteed output current of
180mA supports even the most demanding ADSL CPE require-
ments with low harmonic distortion. Differential driver applica-
tions will deliver < –75dBc distortion at the peak upstream power
levels of full rate ADSL. Using a differential driver design, as
shown below, the OPA2607 can deliver a high 38Vp-p voltage
swing into a 1:0.8 step-down transformer to meet the ADSL CPE
upstream power requirements. This low turns ratio actually pro-
vides a step up to the much weaker downstream signal arriving on
the line side of this transformer, extending the DSL modem’s
reach.
Power control features are included in the SO-14 package version
to allow system power to be minimized. Two logic control lines
allow four quiescent power settings. These include full power,
power cutback for short loops, idle state for no signal transmission
but line match maintenance, and shutdown for power off with a
high impedance output. An additional I
mum supply current to be adjusted 25% from the nominal value.
Connecting this pin to +V
to 20mA, increasing the peak output current available, while
connecting this pin to –V
to 12mA where a lower peak output current is required. The
digital control lines continue to scale the total quiescent current
from these new maximum levels in the same proportional steps as
before.
The OPA2607 is available in three package styles. For power
driver applications, a thermally enhanced
with a heat slug is available in both SO-8 and SO-14 pinouts. For
lower power receiver applications, a standard SO-8 package is
available.
OPA2607 RELATED PRODUCTS
SINGLES
OPA681
OPA2681
OPA2677
DUALS
CC
CC
will decrease the full power quiescent
will increase the full power quiescent
OPA3681
TRIPLES
OPA2607
ADJ
Printed in U.S.A. August, 2000
OPA2607
pin allows the maxi-
Single +12V Capable
Single +12V Capable
NOTES
package
®

Related parts for OPA2607

Related keywords