LM057QCTT03 Sharp Microelectronics of the Americas, LM057QCTT03 Datasheet - Page 4

• Manufacturer Part Number: LM057QCTT03
• Description: Device Specification For Passive Matrix LCD Module
• Manufacturer: Sharp Microelectronics of the Americas

@HARP
11) Disassembling
9)
10) If the LCD module is stored at below specified temperature, the LC material may freeze and be deteriorated
8)
7)
6) As CMOS LSIs are equipped in this module, following countermeasures must be taken to avoid
within specified temperature range.
Liquid state and it may not revert to its original state. Therefore, the LCD module should always be stored
If it is stored at above specified temperature, the molecular orientation of the LC material may change to
6. Others
5. Transportation/storage
agent(dealcoho1 or deoxym) to prevent discoloration
4. Humidity
chassis through coupling effect. The inverter circuit needs to be designed taking the level of leakage current
to ensure specified brightness.
into consideration. Thorough evaluation is needed for LCD module and inverter built into its ho& equipment
Avoid the exposure of the module to the direct sun-light or strong ultraviolet light for a long time.
The brightness of the LCD module may be affected by the routing of CCFI cables due to leakage to the
electrostatics charges.
3. Floor
Static eliminator
The laminator@rotective
It should be peeled off slowly using static eliminator.
Do not use any materials which emit gas from epoxy resin(hardener for amine) and silicone adhesive
2. Equipment
over 50%RH.
Proper humidity helps in reducing the chance of generating electrostatic charges. Humidity
The storage materials also need to be anti-static treated because there is a possibility that the human body or
storage materials such as containers may be statically charged by friction or peeling.
1. Operator
or friction action(ex: conveyer, soldering iron, working table). Earth the equipment through proper
resistance(electrostatic
Floor is the important part to drain static electricity which is generated by operators or equipment.
There is a possibility that charged static electricity is not properly drained in case of insulating floor.
Set the electrostatic earth(1 X lO”S2).
There is a possibiiity that the static electricity is charged to the equipment which have a function of
clothes.
Ware the electrostatic shielded clothes because human body may be statically charged if not ware shielded
the LCD module can cause permanent damage and it should be strictly avoided
should also be installed to the work bench to prevent LCD module from static charge.
earth: 1 X 10” 9).
film) is attached on the surface of LCD panel to prevent it from scratches or stains.
I
SPEC
LC99908
No.
of polarizer due to gas.
I
MODEL
LM057QCTT03
No.
should be kept
I
PAGE
peeling
2