WM8973 Wolfson Microelectronics Ltd., WM8973 Datasheet - Page 22

no-image

WM8973

Manufacturer Part Number
WM8973
Description
The WM8976 is a low power, high quality stereo codec designed for portable applications such as Digital still camera or Digital Camcorde
Manufacturer
Wolfson Microelectronics Ltd.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
WM8973G
Manufacturer:
PHILIPS
Quantity:
225
Part Number:
WM8973G
Manufacturer:
WM
Quantity:
20 000
Part Number:
WM8973LEFL
Quantity:
156
Part Number:
WM8973LGEFL
Manufacturer:
WOLFSON
Quantity:
782
Part Number:
WM8973LGEFL/RV
Manufacturer:
WOLFSON
Quantity:
20 000
Part Number:
WM8973Q
Manufacturer:
LT
Quantity:
183
WM8973L
w
ANALOGUE TO DIGITAL CONVERTER (ADC)
The WM8973L uses a multi-bit, oversampled sigma-delta ADC for each channel. The use of multi-bit
feedback and high oversampling rates reduces the effects of jitter and high frequency noise. The
ADC Full Scale input level is proportional to AVDD. With a 3.3V supply voltage, the full scale level is
1.0 Volts r.m.s. Any voltage greater than full scale may overload the ADC and cause distortion.
ADC DIGITAL FILTER
The ADC filters perform true 24 bit signal processing to convert the raw multi-bit oversampled data
from the ADC to the correct sampling frequency to be output on the digital audio interface. The digital
filter path is illustrated in Figure 9.
Figure 9 ADC Digital Filter
The ADC digital filters contain a digital high pass filter, selectable via software control. The high-pass
filter response is detailed in the Digital Filter Characteristics section. When the high-pass filter is
enabled the dc offset is continuously calculated and subtracted from the input signal. By setting
HPOR, the last calculated dc offset value is stored when the high-pass filter is disabled and will
continue to be subtracted from the input signal.
subtracted value will not change unless the high-pass filter is enabled. This feature can be used for
calibration purposes. In addition the highpass filter may be enabled separately on the left and right
channels (see Table 11).
The output data format can be programmed by the user to accommodate stereo or monophonic
recording on both inputs. The polarity of the output signal can also be changed under software
control. The software control is shown in Table 10.
FROM ADC
DECIMATOR
DIGITAL
DIGITAL
FILTER
ADCHPD
DIGITAL
HPF
If the DC offset is changed, the stored and
INTERFACE
TO DIGITAL
AUDIO
PD Rev 4.2 September 2005
Production Data
22

Related parts for WM8973