SMB380 Jennic, SMB380 Datasheet - Page 49

• Manufacturer Part Number: SMB380
• Description: Smb380 Triaxial Acceleration Sensor
• Manufacturer: Jennic

9. Internal logic functions
The sensor IC can inform the host system about specific conditions (e.g. new data ready flag or
a
is not taking place. This feature can be used as “freefall indicator”, “wake-up” or “data ready
fl
T
id
b
9.1 Freefall logic
For freefall detection the absolute value of the acceleration data of all axes are investigated
(global criteria). A freefall situation is likely to occur when all axes fall below a lower threshold
value (“LG_thres”). The interrupt pin will be raised high if the threshold is passed for a minimum
duration. The duration time can be programmed in units of ms (max. 255ms).
The function “Freefall Interrupt” can be switched on/off by a control bit which is located within
the image of the non-volatile memory. Thus this functionality can be stored as default setting of
the sensor IC (EEPROM) but can also rapidly be changed within the image.
The reset of the freefall interrupt can be accomplished by means of a master reset of the
interrupt flag (latched interrupt) or the reset can be triggered by the acceleration signal itself
(validation of a programmable “hysteresis”).
See also section 3.2.7.
9.2 High-g logic
For indicating high-g events an upper threshold can be programmed. This logic can also be
activated by a control bit. Threshold, duration and reset behaviour can be programmed. The
high-g and freefall criteria can be logically combined with an <OR>.
See also section 3.2.8.
Rev. 1.3
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
7211RB11
ag” for instance.
cceleration thresholds passed) by setting an interrupt pin high even if interface communication
e defined specifically.
he interrupt performance can be programmed by means of control bits. Thus the criteria to
entify a special event can be tailored to a customer’s application and the sensor IC output can
. Specifications are subject to change without notice.
Triaxial acceleration sensor
Preliminary Data Sheet
SMB380
Page 49
Bosch Sensortec
18-September-2007