B121EW03-V8 AUO, B121EW03-V8 Datasheet - Page 4

• Manufacturer Part Number: B121EW03-V8
• Description: LCD Module
• Manufacturer: AUO

1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
6) Since CMOS LSI is used in this module, take care of static electricity and insure
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for
12) Cold cathode fluorescent lamp (CCFL) in LCD contains a small amount of mercury.
13) Small amount of materials having no flammability grade is used in the LCD module.
14) The LCD module is designed so that the CCFL in it is supplied by Limited Current
B121EW03 V8 Version 1.0
spots.
surface.
human earth when handling.
taken out from the container, do not press the center of the CCFL Reflector edge.
Instead, press at the far ends of the CCFL Reflector edge softly. Otherwise the TFT
Module may be damaged.
tilt the Interface Connector of the TFT Module.
example), do not twist nor bend the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are
applied to the TFT Module from outside.
damaged.
Please follow local ordinances or regulations for disposal.
The LCD module should be supplied by power complied with requirements of Limited
Power Source (IEC60950 or UL1950), or be applied exemption.
Circuit (IEC60950 or UL1950). Do not connect the CCFL in Hazardous Voltage Circuit.
AU OPTRONICS CORPORATION
Product Specification
Otherwise the TFT Module may be
4 of 35