AN1385 STMicroelectronics, AN1385 Datasheet - Page 20

• Manufacturer Part Number: AN1385
• Description: PSD913F2 - 68HC11 DESIGN GUIDE
• Manufacturer: STMicroelectronics

AN1385 - APPLICATION NOTE
Programming the PSD
The simple11.obj file can be programmed into the PSD by one of three ways:
Programming with FlashLINK
Connect the FlashLINK JTAG-ISP cable to your PC parallel port. Click the 'JTAG-ISP' box in the design
flow window. You should see the following screen:
This window enables you to perform JTAG-ISP operations and also offers a loop back test for your
FlashLINK cable. If this is your first use, test your FlashLINK cable and PC parallel port by clicking the 'HW
Setup' button, then click 'LoopTest' button and follow the directions.
Now let's define our JTAG-ISP environment. For this example project, PSDsoft Express should have filled
in the folder and filename of the object file to program, the PSD device, and the JTAG-ISP operation, as
shown in the screen above. For this design example, we have chosen to use all six JTAG-ISP pins (in-
stead of four). Be sure to indicate "6 pins" as shown above to achieve minimum JTAG-ISP programming
times (refer to Application Note AN1153 for details on six pins vs. four)
To begin programming, connect the JTAG cable to the target system, power-up the target system, and
click 'Execute' on the JTAG screen. The Log window at the bottom of the JTAG screen shows the
progress. Programming should just take a few seconds.
There are optional choices available when the 'Properties.." button is clicked. One choice includes setting
20/35
– The ST FlashLINK JTAG cable, which connects to the PC parallel port.
– The ST PSDpro device programmer, which also uses the PC parallel port.
– Third-party programmers, from Stag, Needhams, and others. See our web site at www.wafes-
cale.com for compatible third-party programmers.