sam3s16 ATMEL Corporation, sam3s16 Datasheet - Page 45

no-image

sam3s16

Manufacturer Part Number
sam3s16
Description
At91sam Arm-based Flash Mcu
Manufacturer
ATMEL Corporation
Datasheet
12.11 Digital-to-Analog Converter (DAC)
12.12 Static Memory Controller
12.13 Analog Comparator
11117AS–ATARM–12-Jul-11
• Programmable gain: 1, 2, 4
• Up to 2 channel 12-bit DAC
• Up to 2 mega-samples conversion rate in single channel mode
• Flexible conversion range
• Multiple trigger sources for each channel
• 2 Sample/Hold (S/H) outputs
• Built-in offset and gain calibration
• Possibility to drive output to ground
• Possibility to use as input to analog comparator or ADC (as an internal wire and without S/H
• Two PDC channels
• Power reduction mode
• 16-Mbyte Address Space per Chip Select
• 8- bit Data Bus
• Word, Halfword, Byte Transfers
• Programmable Setup, Pulse And Hold Time for Read Signals per Chip Select
• Programmable Setup, Pulse And Hold Time for Write Signals per Chip Select
• Programmable Data Float Time per Chip Select
• External Wait Request
• Automatic Switch to Slow Clock Mode
• Asynchronous Read in Page Mode Supported: Page Size Ranges from 4 to 32 Bytes
• NAND FLASH additional logic supporting NAND Flash with Multiplexed Data/Address buses
• Hardware Configurable number of chip select from 1 to 4
• Programmable timing on a per chip select basis
• One analog comparator
• High speed option vs. low power option
• Selectable input hysteresis:
• Minus input selection:
• Plus input selection:
stage)
– 0, 20 mV, 50 mV
– DAC outputs
– Temperature Sensor
– ADVREF
– AD0 to AD3 ADC channels
– All analog inputs
SAM3S16 Preliminary
45

Related parts for sam3s16