m29dw324d Numonyx, m29dw324d Datasheet - Page 11

• Manufacturer Part Number: m29dw324d
• Description: 32 Mbit 4mb X8 Or 2mb X16, Dual Bank 16 16, Boot Block 3v Supply Flash Memory
• Manufacturer: Numonyx

operation. During Program or Erase operations
Ready/Busy is Low, V
pedance during Read mode, Auto Select mode
and Erase Suspend mode.
After a Hardware Reset, Bus Read and Bus Write
operations cannot begin until Ready/Busy be-
comes high-impedance. See
Block Temporary Unprotect AC Characteristics
and
AC
The use of an open-drain output allows the Ready/
Busy pins from several memories to be connected
to a single pull-up resistor. A Low will then indicate
that one, or more, of the memories is busy.
Byte/Word Organization Select (BYTE). The
Byte/Word Organization Select pin is used to
switch between the x8 and x16 Bus modes of the
memory. When Byte/Word Organization Select is
Low, V
High, V
Waveforms.
Figure 16., Reset/Block Temporary Unprotect
IL
IH
, the memory is in x8 mode, when it is
, the memory is in x16 mode.
OL
. Ready/Busy is high-im-
Table 19., Reset/
V
vides the power supply for all operations (Read,
Program and Erase).
The Command Interface is disabled when the V
Supply Voltage is less than the Lockout Voltage,
V
cidentally damaging the data during power up,
power down and power surges. If the Program/
Erase Controller is programming or erasing during
this time then the operation aborts and the memo-
ry contents being altered will be invalid.
A 0.1µF capacitor should be connected between
the V
pin to decouple the current surges from the power
supply. The PCB track widths must be sufficient to
carry the currents required during Program and
Erase operations, I
V
measurements. The device features two V
which must be both connected to the system
ground.
CC
LKO
SS
Ground. V
Supply Voltage (2.7V to 3.6V). V
. This prevents Bus Write operations from ac-
CC
Supply Voltage pin and the V
M29DW324DT, M29DW324DB
SS
CC3
is the reference for all voltage
.
SS
CC
Ground
SS
11/50
pins
pro-
CC