LMV710ANDLMV711 National Semiconductor Corporation, LMV710ANDLMV711 Datasheet - Page 17

• Manufacturer Part Number: LMV710ANDLMV711
• Description: Low Power, Rrio op Amps With High Output Current Drive And Shutdown Option
• Manufacturer: National Semiconductor Corporation

Reel Dimensions
Note: UNLESS OTHERWISE SPECIFIED
TAPE
8 mm
SIZE
1. MATERIAL:
2. CONTROLLING DIMENSION IS MILLIMETER, DIMENSIONS IN
INCHES ROUNDED.
3. SURFACE RESISTIVITY: 10
4. ALL OUTPUT REELS SHALL BE UNIFORM IN SHADE.
5. PACKING OF REELS IN CONTAINERS MUST ENSURE NO DAM-
AGE TO THE REEL.
6. SURFACE FINISH OF THE FLANGES SHALL BE SMOOTH,
MATTE FINISH PREFERRED.
7. ALL EDGES, ESPECIALLY THE TAPE ENTRY EDGES, MUST BE
FREE OF BURRS.
8. THE REEL SHOULD NOT WARP IN THE STORAGE TEMPERA-
TURE OF 67˚C MAXIMUM.
9. GLASS TRANSITION TEMPERATURE (T
REEL SHALL BE LOWER THAN −20˚C.
POLYSTYRENE/PVC (WITH ANTISTATIC COATING).
OR POLYSTYRENE/PVC, ANTISTATIC
OR POLYSTYRENE/PVC, CONDUCTIVE.
(177.8)
DIM A
7.00
DIM B
(1.5)
.059
10
OHM/SQ MAXIMUM.
.512 + .020/−.008
(13 +0.5/−0.2)
DIM C
g
) OF THE PLASTIC
DIM D
(20.2)
.795
17
DIM N
2.165
(55)
10. ALL GATING FROM THE MOLD MUST BE PROPERLY RE-
MOVED.
11. NO FLASHES ARE TO BE PRESENT ALONG THE PARTING
LINES.
12. ALLOWABLE RADIUS FOR CORNERS AND EDGES IS .012
INCHES/0.3 MILLIMETERS MINIMUM.
13. SINK MARKS THAT WILL CAUSE A CHANGE TO THE SPECI-
FIED DIMENSIONS OR SHAPE OF THE REELS ARE NOT AL-
LOWED.
14. MOLDED REELS SHALL BE FREE OF COSMETIC DEFECTS
SUCH AS VOIDS. FLASHING, EXCESSIVE FLOW MARKS, ETC.
15. THERE MUST BE NO MISMATCH BETWEEN MATING PARTS.
16. MOLDED REELS SHALL BE ANTISTATIC COATED OR
BLENDED.
17. THE SOT23-5L AND SOT23-6L PACKAGE USE THE 7-INCH
REEL.
.331 + .059/−.000
(8.4 + 1.5/0)
DIM W1
DIM W2
(14.4)
.567
(7.9 - 10.9)
(LSL-USL)
.311 - .429
DIM W3
www.national.com
10132554