xe0055cs2 ETC-unknow, xe0055cs2 Datasheet - Page 5

• Manufacturer Part Number: xe0055cs2
• Description: Miniature Telephone Line Interface Module Applications
• Manufacturer: ETC-unknow

XE0055CS2 Typical Connection Diagram
Notes:
FB1 and FB2 are ferrite beads. They work in conjunction with Capacitors C1 and C2 to eliminate EMI from the
telephone cable. Xecom recommends a TDK CB30-1812 surface mount ferrite bead because it provides over 100
ohms impedance at 100 MHz.
C1 and C2 ground any EMI signal present on Tip and Ring. Xecom recommends a Sprague 30GAT47 capacitor.
This is a 470 pFd capacitor rated for 3000 Volts. The high voltage rating is required to maintian the required
isolation barrier between the telephone line and ground.
RV1 is a solid-state protection device to reduce the likelihood of damage due to lightning strikes. RV1 works in
conjunction with the two 10 ohm resistors to protect the XE0055CS2 circuitry. Xecom recommends the Teccor
P3100 Sidactor for this function. Its typical breakover voltage of 310 volts prevents the XE0055CS2 from being
exposed to voltage surges while being rated high enough to prevent being triggered by an incoming Ring signal.
XECOM
RJ11
C1
C2
RC144D
To Embedded System Host
RINGD
TXA1
TXA2
RXA
FB1
FB1
OH
VC
340 ohms
10k ohms
(5)
RV1
56k ohms
10 ohms
10 ohms
+5 Volts
XE0055CS2
o
o
o
o
o
o
o
o
o
Pin 1 Ring
Pin 2 Tip
Pin 3 OH
Pin 4 T1
Pin 5 Gnd
Pin 6 VCC
Pin 7 T2
Pin 8 /RI
Pin 9 CD
XE0055CS2