hb288032c6 Renesas Electronics Corporation., hb288032c6 Datasheet - Page 6

• Manufacturer Part Number: hb288032c6
• Description: Compactflash? 256 Mbyte/192 Mbyte/160 Mbyte/128 Mbyte 96 Mbyte/64 Mbyte/32 Mbyte
• Manufacturer: Renesas Electronics Corporation.

HB288256/192/160/128/096/064/032C6
Signal name
-CSEL
(PC Card Memory mode)
-CSEL
(PC Card I/O mode)
-CSEL
(True IDE mode)
D15 to D0
(PC Card Memory mode)
D15 to D0
(PC Card I/O mode)
D15 to D0
(True IDE mode)
GND
(PC Card Memory mode)
GND
(PC Card I/O mode)
GND
(True IDE mode)
-INPACK
(PC Card Memory mode)
-INPACK
(PC Card I/O mode)
Input Acknowledge
-INPACK
(True IDE mode)
-IORD
(PC Card Memory mode)
-IORD
(PC Card I/O mode)
-IORD
(True IDE mode)
6
Direction Pin No.
I
I/O
—
O
I
39
31, 30, 29, 28,
27, 49, 48, 47, 6,
5, 4, 3, 2, 23, 22,
21
1, 50
43
34
Description
This signal is not used.
This signal is used to configure this device as a
Master or a Slave when configured in the True IDE
mode. When this pin is grounded, this device is
configured as a Master. When the pin is open, this
device is configured as a Slave.
Data bus is D15 to D0. D0 is the LSB of the even byte
of the word. D8 is the LSB of the odd byte of the
word.
Ground
This signal is not used and should not be connected
at the host.
This signal is asserted low by this card when the card
is selected and responding to an I/O read cycle at the
address that is on the address bus during -CE and
-IORD are low. This signal is used for the input data
buffer control.
This signal is not used and should not be connected
at the host.
This signal is not used.
-IORD is used for control of read data in I/O task file
area. This card does not respond to -IORD until I/O
card interface setting up.
-IORD is used for control of read data in I/O task file
area. This card does not respond to -IORD until True
IDE interface setting up.