hb28d032bp2 Renesas Electronics Corporation., hb28d032bp2 Datasheet - Page 9

• Manufacturer Part Number: hb28d032bp2
• Description: Mobile Embedded Flash With Multimediacard-tm Interface 16 Mbyte/32 Mbyte
• Manufacturer: Renesas Electronics Corporation.

Registers
These Hitachi Mobile Embedded Flashes contain the following information registers:
Name
OCR
CID
RCA
CSD
The CID and RCA are used for identifying and addressing these Hitachi Mobile Embedded Flashes . The
CSD contains the card specific data record. This record is a set of information fields to define the operation
conditions of these Hitachi Mobile Embedded Flashes.
For the user, the CID is read only register. The CSD contains read only area and some of one-time or
multiple programmable area by the customer or provider. They are read out by special commands (refer to
Chapter “Commands”). The RCA registers are write only registers. Unlike CID and CSD, RCA looses its
contents after powering down the card. Its value is reassigned in each initialization cycle. The
MultiMediaCard registers usage in SPI mode is summarized in Table “MultiMediaCard Registers in SPI
Mode”:
MultiMediaCard Registers in SPI Mode
Name
OCR
CID
RCA
CSD
Width
32
128
16
128
Available in SPI mode Width (Bytes)
Yes
Yes
No
Yes
Type
Programmed by the
manufacturer.
Read only for user
Programmed by the
manufacturer.
Read only for user
Programmed during
initialization, not readable
Programmed by the
manufacturer. Partially
programmable by the user.
4
16
16
Description
Supported voltage range, card power up status bit
Card identification number, card individual number for
identification.
Relative card address, local system address of a card,
dynamically assigned by the host during initialization.
Card specific data, information about the card operation
conditions.
Description
Operation condition register.
Card identification data (serial number, manufacturer ID
etc.)
Card specific data, information about the card operation
conditions.
HB28E016/D032BP2
9