ha16158 Renesas Electronics Corporation., ha16158 Datasheet - Page 13

• Manufacturer Part Number: ha16158
• Description: Pfc & Pwm Control Ic
• Manufacturer: Renesas Electronics Corporation.

HA16158P/FP
3. Soft Start Circuit (for PFC Control)
This function gradually increases the pulse width of the PFC-OUT pin from a 0% duty cycle at start-up to prevent a
sudden increase in the pulse width that may cause problems such as transient stress on external parts or overshoot of the
PFC output voltage (B+ voltage).
The soft start time can easily be set with a single external capacitance.
Soft start time tss-pfc is determined by PFC-SS pin connection capacitance Css-pfc and an internal constant, and can be
estimated using the equation shown below.
Soft start time tss-pfc is the time until the PFC-SS pin voltage reaches lower-end voltage 0.65 V of the IC-internal
RAMP voltage waveform after VREF starts up following UVLO release.
Soft start time tss-pfc when Css-pfc is 3.3 nF is given by the following equation.
In addition, when you do not use a soft start function, please ground this terminal.
Rev.2.00 Jan 30, 2007 page 13 of 23
tss-pfc =
* Iss-pfc: PFC-SS pin sink current, 25 µA typ.
≈ 5.7 [ms]
V_ramp
(internal signal)
PFC-SS
comp. out
(internal signal)
PFC-OUT
Css-pfc × (VREF − Vramp-L)
Iss-pwm
3.4V
=
33 [nF] × (5 − 0.65)
Figure 3
25 [µA]
V_PFC-SS