icx209akb Sony Electronics, icx209akb Datasheet - Page 16

• Manufacturer Part Number: icx209akb
• Description: Diagonal 4.5mm Type 1/4 Ccd Image Sensor For Pal Color Video Cameras
• Manufacturer: Sony Electronics

Notes on Handling
1) Static charge prevention
2) Soldering
3) Dust and dirt protection
4) Do not expose to strong light (sun rays) for long periods, color filters will be discolored. When high
5) Exposure to high temperature or humidity will affect the characteristics. Accordingly avoid storage or usage
6) CCD image sensors are precise optical equipment that should not be subject to too much mechanical
7) Eclipse (to get dark around the four corners of the picture) may occur when some object lenses are in the
CCD image sensors are easily damaged by static discharge. Before handling be sure to take the following
protective measures.
a) Either handle bare handed or use non-chargeable gloves, clothes or material.
b) When handling directly use an earth band.
c) Install a conductive mat on the floor or working table to prevent the generation of static electricity.
d) Ionized air is recommended for discharge when handling CCD image sensor.
e) For the shipment of mounted substrates, use boxes treated for the prevention of static charges.
a) Make sure the package temperature does not exceed 80°C.
b) Solder dipping in a mounting furnace causes damage to the glass and other defects. Use a ground 30W
c) To dismount an image sensor, do not use a solder suction equipment. When using an electric desoldering
Image sensors are packed and delivered by taking care of protecting its glass plates from harmful dust and
dirt. Clean glass plates with the following operation as required, and use them.
a) Operate in clean environments (around class 1000 is appropriate).
b) Do not either touch glass plates by hand or have any object come in contact with glass surfaces. Should
c) Clean with a cotton bud and ethyl alcohol if the grease stained. Be careful not to scratch the glass.
d) Keep in a case to protect from dust and dirt. To prevent dew condensation, preheat or precool when
e) When a protective tape is applied before shipping, just before use remove the tape applied for
luminance objects are imaged with the exposure level control by electronic-iris, the luminance of the image-
plane may become excessive and discolor of the color filter will possibly be accelerated. In such a case, it is
advisable that taking-lens with the automatic-iris and closing of the shutter during the power-off mode should
be properly arranged. For continuous using under cruel condition exceeding the normal using condition,
consult our company.
in such conditions.
shocks.
open iris state.
Also use conductive shoes.
soldering iron and solder each pin in less than 2 seconds. For repairs and remount, cool sufficiently.
tool, use a thermal controller of the zero cross On/Off type and connect it to ground.
dirt stick to a glass surface, blow it off with an air blower. (For dirt stuck through static electricity ionized air
is recommended.)
moving to a room with great temperature differences.
electrostatic protection. Do not reuse the tape.
Top view
Effective
sensor
– 16 –
image
area
Sealed resin exuded area
ICX209AKB