icx063al Sony Electronics, icx063al Datasheet - Page 10

• Manufacturer Part Number: icx063al
• Description: Diagonal 11mm Type 2/3 Ccd Image Sensor For Ccir B/w Video Camera
• Manufacturer: Sony Electronics

3. Smear
4. Video signal shading
5. Dark signal
6. Dark signal shading
7. Flicker
8. Lag
Sm =
Set to standard imaging condition II. With the lens diaphragm at F5.6 to F8, adjust the luminous intensity to
500 times the intensity with average value of the signal output, 200mV. When the readout clock is stopped
and the charge drain is executed by the electronic shutter at the respective H blankings, measure the
maximum value VSm [mV] of the signal output, and substitute the value into the following formula.
Set to standard imaging condition II. With the lens diaphragm at F5.6 to F8, adjust the luminous intensity
so that the average value of the signal output is 200 mV. Then measure the maximum (Vmax [mV]) and
minimum (Vmin [mV]) values of the signal output, and substitute the values into the following formula.
SH = (Vmax – Vmin)/200
Measure the average value (Vdt [mV]) of the signal output with the device ambient temperature 60°C and
the device in the light-obstructed state, using the horizontal idle transfer level as a reference.
After measuring 5, measure the maximum (Vdmax [mV]) and minimum (Vdmin [mV]) values of the dark
signal output, and substitute the values into the following formula.
Set to standard imaging condition II. Adjust luminous intensity so that the average value of the signal
output is 200mV, and then measure the difference in the signal level between fields ( Vf [mV]). Then
substitute the value into the following formula.
F = ( Vf/200)
Adjust the signal output value generated by strobe light to 200mV. After setting the strobe light so that it
strobes with the following timing, measure the residual signal (Vlag). Substitute the value into the following
formula.
Lag = (Vlag/200)
Vdt = Vdmax – Vdmin [mV]
VSm
200
Strobe light
Output
timing
FLD
SG1
500
100 [%]
1
100 [%]
10
1
100 [%]
Light
100 [%] (1/10V method conversion value)
Signal output 200mV
– 10 –
Vlag (lag)
ICX063AL