LTC3616 LINER [Linear Technology], LTC3616 Datasheet - Page 20

• Manufacturer Part Number: LTC3616
• Description: 6A, 4MHz Monolithic Synchronous Step-Down DC/DC Converter
• Manufacturer: LINER [Linear Technology]

LTC3616
APPLICATIONS INFORMATION
The LTC3616 allows the user to control the slew rate of the
switching node SW by using the SRLIM/DDR pin. Tying
this pin to ground selects the fastest slew rate. The slow-
est slew rate is selected when the pin is open. Connecting
a resistor (between 10k and 100k) from SRLIM pin to
ground adjusts the slew rate between the maximum and
minimum values. The reduced dV/dt of the switch node
results in a significant reduction of the supply and ground
ringing, as well as lower radiated EMI.
Particular attention should be used with very high switching
frequencies. Using the slowest slew rate (SRLIM open)
can reduce the minimum duty cycle capability.
Output Voltage Tracking Input
If the DDR pin is not tied to SV
0.6V, the run state is entered and the MODE selection, power
good and current foldback circuits are enabled.
In the run state, the TRACK/SS pin can be used for track-
ing down/up the output voltage of another supply. If the
V
tracking state and V
age. If the TRACK/SS pin drops below 0.2V, the switching
frequency is reduced to ensure that the minimum duty
cycle limit does not prevent the output from following
the TRACK/SS pin. The run state will resume if V
again exceeds 0.6V and V
precision reference (see Figure 8).
Through the TRACK/SS pin, the output voltage can be set
up for either coincident or ratiometric tracking, as shown
in Figure 6.
To implement the coincident tracking behavior in Fig-
ure 6a, connect an extra resistive divider to the output
of the master channel and connect its midpoint to the
TRACK/SS pin for the slave channel. The ratio of this
divider should be selected to be the same as that of the
slave channel’s feedback divider (Figure 7a). In this track-
ing mode, the master channel’s output must be set higher
than slave channel’s output. To implement the ratiometric
tracking behavior in Figure 6b, different resistor divider
values must be used as specified in Figure 7b.
20
TRACK/SS
drops below 0.6V, the LTC3616 enters the down
OUT
is referenced to the TRACK/SS volt-
OUT
is referenced to the internal
IN
, once V
TRACK/SS
TRACK/SS
exceeds
Figure 6. Two Different Modes of Output Voltage Tracking
V
V
OUT2
OUT2
R4
R2
R1
R2
Figure 7b. Setup for Ratiometric Tracking
Figure 7a. Setup for Coincident Tracking
LTC3616 CHANNEL 2
LTC3616 CHANNEL 2
V
V
FB2
FB2
TRACK/SS2
TRACK/SS2
LTC3616
LTC3616
SLAVE
SLAVE
(6b) Ratiometric Tracking
(6a) Coincident Tracking
TIME
TIME
R4 ≤ R3
R4
R2
R5
R6
V
V
OUT1
OUT1
R3
R2
R3 R1/R2 < R5/R6
R4
LTC3616 CHANNEL 1
LTC3616 CHANNEL 1
V
V
FB1
FB1
TRACK/SS1
TRACK/SS1
LTC3616
MASTER
LTC3616
MASTER
3616 F06
V
V
V
V
OUT1
OUT2
OUT1
OUT2
V
3616 F07b
IN
V
3616 F07a
IN
3616f