SAA7710T/N104 PHILIPS [NXP Semiconductors], SAA7710T/N104 Datasheet - Page 6

• Manufacturer Part Number: SAA7710T/N104
• Description: Dolby* Pro Logic Surround; Incredible Sound
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
A
The possible modes of operation are discussed in more
detail in the “SAA7710T Dolby Pro Logic Programming
Guide, Application Note AN95063” . This also includes
which features are available for a given system clock
frequency and sample frequency and the possible input
configurations.
Clock circuit and oscillator
The chip has an on board crystal clock oscillator. The block
schematic of this Pierce oscillator is shown in
Figs 3 and 4. The active element needed to compensate
for the loss resistance of the crystal is the amplifier Gm.
This amplifier is placed between the XTAL (output) pin and
the OSC (sense) pin. The gain of the oscillator is internally
controlled by the automatic gain control. This prevents too
much power loss in the crystal. The higher harmonics are
then as low as possible. The signals on the OSC and XTAL
pin are differentially amplified.
The oscillator has these two modes of operation:
1998 Mar 13
DDITIONAL INFORMATION
The crystal oscillator mode: in this mode (see Fig.3),
a quartz crystal oscillator is used to generate a clock
signal which is subsequently divided by 2 to ensure that
the final clock signal has a 50% duty cycle.
The oscillator circuit components R
depend on the crystal. In the case of an overtone
oscillator, the ground harmonic is filtered out by L1 and
C3. Pin SHTCB is held low so that the divided signal is
selected. Only a quartz crystal should be used in this
mode.
Dolby* Pro Logic Surround;
Incredible Sound
bias
and C1, C2
6
In order to be able to control the phase of the clock signal
during testing the divider is skipped and the signal is
directly fed to the circuit via the multiplexer in the TEST
position.
S
The power supply connections to the oscillator are
separated from the other supply lines to minimise
feedback from on-chip ground bounce to the oscillator
circuit. Noise on the power supply affects the AGC
operation so the power supply should be decoupled.
The V
V
UPPLY OF THE CRYSTAL OSCILLATOR
DD_XTAL
The slave oscillator mode: in this mode (see Fig.4),
the oscillator circuit acts as a slave driven by a master
system clock. The clock divider can be switched on or off
using pin SHTCB. When the divider is not used, the duty
cycle of the clock will depend on the master system
clock duty cycle and the rising and falling edge times.
This places a tolerance of 5% on the 50% duty cycle of
the master system clock (see Chapter “AC
characteristics”).
SS_XTAL
as positive supply.
pin is used as ground supply and the
Product specification
SAA7710T