AT89C2051X2 ATMEL [ATMEL Corporation], AT89C2051X2 Datasheet - Page 6

• Manufacturer Part Number: AT89C2051X2
• Description: 8-bit Microcontroller with 2K Bytes Flash
• Manufacturer: ATMEL [ATMEL Corporation]

Restrictions on
Certain Instructions
Branching Instructions
MOVX-related Instructions,
Data Memory
Program Memory
Lock Bits
6
AT89C2051x2
The AT89C2051x2 is an economical and cost-effective member of Atmel’s growing fam-
ily of microcontrollers. It contains 2K bytes of Flash program memory. It is fully
compatible with the MCS-51 architecture, and can be programmed using the MCS-51
instruction set. However, there are a few considerations one must keep in mind when
utilizing certain instructions to program this device.
All the instructions related to jumping or branching should be restricted such that the
destination address falls within the physical program memory space of the device, which
is 2K for the AT89C2051x2. This should be the responsibility of the software program-
mer. For example, LJMP 7E0H would be a valid instruction for the AT89C2051x2 (with
2K of memory), whereas LJMP 900H would not.
LCALL, LJMP, ACALL, AJMP, SJMP, JMP @A+DPTR
These unconditional branching instructions will execute correctly as long as the pro-
grammer keeps in mind that the destination branching address must fall within the
physical boundaries of the program memory size (locations 00H to 7FFH for the
AT89C2051x2). Violating the physical space limits may cause unknown program
behavior.
CJNE [...], DJNZ [...], JB, JNB, JC, JNC, JBC, JZ, JNZ
With these conditional branching instructions, the same rule above applies. Again, vio-
lating the memory boundaries may cause erratic execution.
For applications involving interrupts, the normal interrupt service routine address loca-
tions of the 80C51 family architecture have been preserved.
The AT89C2051x2 contains 128 bytes of internal data memory. Thus, in the
AT89C2051x2, the stack depth is limited to 128 bytes, the amount of available RAM.
External DATA memory access is not supported in this device, nor is external PRO-
GRAM memory execution. Therefore, no MOVX [...] instructions should be included in
the program.
A typical 80C51 assembler will still assemble instructions, even if they are written in vio-
lation of the restrictions mentioned above. It is the responsibility of the controller user to
know the physical features and limitations of the device being used and adjust the
instructions used correspondingly.
On the chip are two lock bits which can be left unprogrammed (U) or can be pro-
grammed (P) to obtain the additional features listed in the table below:
Lock Bit Protection Modes
Note:
1
2
3
1. The Lock Bits can only be erased with the Chip Erase operation.
Program Lock Bits
LB1
U
P
P
LB2
U
U
P
Protection Type
No program lock features.
Further programming of the Flash is disabled.
Same as mode 2, also verify is disabled.
(1)
3285B–MICRO–10/03