27C256-10 MCNIX [Macronix International], 27C256-10 Datasheet - Page 3

• Manufacturer Part Number: 27C256-10
• Description: 256K-BIT [32K x 8] CMOS EPROM
• Manufacturer: MCNIX [Macronix International]

P/N:PM0203
NOTES:
1. VH = 12.0 V ± 0.5 V
2. X = Either VIH or VIL
3. A1 - A8 = A10 - A14 = VIL (For auto select)
4. See DC Programming characteristics for VPP voltage during programming.
MODE SELECT TABLE
TWO-LINE OUTPUT CONTROL FUNCTION
To accommodate multiple memory connections, a two-
line control function is provided to allow for:
It is recommended that CE be decoded and used as the
primary device-selecting function, while OE be made a
common connection to all devices in the array and
connected to the READ line from the system control bus.
This assures that all deselected memory devices are in
their low-power standby mode and that the output pins
are only active when data is desired from a particular
memory device.
MODE
Read
Output Disable
Standby (TTL)
Standby (CMOS)
Program
Program Verify
Program Inhibit
Manufacturer Code(3)
Device Code(3)
1. Low memory power dissipation,
2. Assurance that output bus contention will not
occur.
CE
VIL
VIL
VIH
VCC±0.3V
VIL
VIH
VIH
VIL
VIL
OE
VIL
VIH
X
X
VIH
VIL
VIH
VIL
VIL
3
SYSTEM CONSIDERATIONS
During the switch between active and standby
conditions, transient current peaks are produced on the
rising and falling edges of Chip Enable. The magnitude
of these transient current peaks is dependent on the
output capacitance loading of the device. At a minimum,
a 0.1 uF ceramic capacitor (high frequency, low inherent
inductance) should be used on each device between
VCC and GND to minimize transient effects. In addition,
to overcome the voltage drop caused by the inductive
effects of the printed circuit board traces on EPROM
arrays, a 4.7 uF bulk electrolytic capacitor should be
used between Vcc and GND for each eight devices. The
location of the capacitor should be close to where the
power supply is connected to the array.
A0
X
X
X
X
X
VIL
VIH
X
X
PINS
A9
X
X
X
X
X
X
VH
VH
X
MX27C256
VPP
VCC
VCC
VCC
VCC
VPP
VPP
VPP
VCC
VCC
REV.5.6, AUG. 26, 2003
High Z
High Z
DIN
DOUT
High Z
C2H
10H
OUTPUTS
DOUT
High Z