27C512-10 MCNIX [Macronix International], 27C512-10 Datasheet - Page 3

• Manufacturer Part Number: 27C512-10
• Description: 512K-BIT [64Kx8] CMOS EPROM
• Manufacturer: MCNIX [Macronix International]

P/N:PM0235
TWO-LINE OUTPUT CONTROL FUNCTION
To accommodate multiple memory connections, a two-
line control function is provided to allow for:
It is recommended that CE be decoded and used as the
primary device-selecting function, while OE be made a
common connection to all devices in the array and
connected to the READ line from the system control bus.
This assures that all deselected memory devices are in
their low-power standby mode and that the output pins
are only active when data is desired from a particular
memory device.
MODE SELECT TABLE
NOTES: 1. VH = 12.0 V ± 0.5 V
1. Low memory power dissipation,
2. Assurance that output bus contention will not
occur.
MODE
Read
Output Disable
Standby (TTL)
Standby (CMOS)
Program
Program Verify
Program Inhibit
Manufacturer Code(3)
Device Code(3)
2. X = Either VIH or VIL
CE
VIL
VIL
VIH
VCC±0.3V
VIL
VIL
VIH
VIL
VIL
OE/VPP
VIL
VIH
X
X
VPP
VIL
VPP
VIL
VIL
3
3. A1 - A8 = A10 - A15 = VIL(For auto select)
4. See DC Programming Characteristics for VPP voltage during
SYSTEM CONSIDERATIONS
During the switch between active and standby
conditions, transient current peaks are produced on the
rising and falling edges of Chip Enable. The magnitude
of these transient current peaks is dependent on the
output capacitance loading of the device. At a minimum,
a 0.1 uF ceramic capacitor (high frequency, low inherent
inductance) should be used on each device between
VCC and GND to minimize transient effects. In addition,
to overcome the voltage drop caused by the inductive
effects of the printed circuit board traces on EPROM
arrays, a 4.7 uF bulk electrolytic capacitor should be
used between VCC and GND for each eight devices.
The location of the capacitor should be close to where
the power supply is connected to the array.
PINS
A0
X
X
X
X
X
X
X
VIL
VIH
programming.
A9
X
X
X
X
X
X
VH
X
VH
MX27C512
OUTPUTS
DOUT
High Z
High Z
High Z
DIN
DOUT
High Z
C2H
91H
REV. 4.8, AUG. 26, 2003