HN58X2508TIE RENESAS [Renesas Technology Corp], HN58X2508TIE Datasheet - Page 22

• Manufacturer Part Number: HN58X2508TIE
• Description: Electrically Erasable and Programmable Read Only Memory
• Manufacturer: RENESAS [Renesas Technology Corp]

HN58X2508I/HN58X2516I
Data Protect
The protection features of the device are summarized in the following table. When the Status Register Write
Disable (SRWD) bit of the Status Register is 0 (its initial delivery state), it is possible to write to the Status
Register provided that the Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN)
instruction, regardless weather write protect (W) is driven high or low.
When the Status Register Write Disable (SRWD) bit of the Status Register is set to 1, two cases need to be
considered, depending on the state of write protect (W):
Regardless of the order of the two events, the Hardware Protected Mode (HPM) can be entered:
The only way to exit the Hardware Protected Mode (HPM) once entered is to pull write protect (W) high.
If write protect (W) is permanently tied high, the Hardware Protected Mode (HPM) can never be activated,
and only the Software Protected Mode (SPM), using the Block Protect (BP1, BP0) bits of the Status Register,
can be used.
Write Protected Block Size
Status register bits
BP1
0
0
1
1
Rev.2.00, Aug.19.2004, page 22 of 27




Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction.
Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction.
(Attempts to write to the Status Register are rejected, and are not accepted for execution). As a
consequence, all the data bytes in the memory area that are software protected (SPM) by the Block
Protect (BP1, BP0) bits of the Status Register, are also hardware protected against data modification.
If write protect (W) is driven high, it is possible to write to the Status Register provided that the
If write protect (W) is driven low, it is not possible to write to the Status Register even if the
By setting the Status Register Write Disable (SRWD) bit after driving write protect (W) low.
By driving write protect (W) low after setting the Status Register Write Disable (SRWD) bit.
BP0
0
1
0
1
Protected blocks
None
Upper quarter
Upper half
Whole memory
Array addresses protected
HN58X2516I
None
600h − 7FFh
400h − 7FFh
000h − 7FFh
HN58X2508I
None
300h − 3FFh
200h − 3FFh
000h − 3FFh