IP113ALF-DS-R01 ETC2 [List of Unclassifed Manufacturers], IP113ALF-DS-R01 Datasheet - Page 7

• Manufacturer Part Number: IP113ALF-DS-R01
• Description: 10 /100Base-Tx/Fx Media Converter
• Manufacturer: ETC2 [List of Unclassifed Manufacturers]

1. PIN Description
Copyright © 2004, IC Plus Corp.
MC operation mode
29
24
38
30
36
Pin no.
X_EN
TP_FORCE
SPEED_MODE
DUPLEX_MODE
FX_FULL
Label
(continued)
O/IPH
O/IPL
Type
IPH
IPH
IPH
IEEE 802.3X enable on TP port and fiber port
1: enable (default),
0: disable
It is an input pin during reset period. The default value is
latched at the end of reset.
After reset, it becomes an output pin for testing.
It should be connected to GND through a 1k ohm resister
to set 0.
Local TP port auto negotiation enable
1: TP port supports auto-negotiation with limited capability
0: TP port supports auto-negotiation with 10M/100M, full/
The default value may be updated by either programming
EEPROM register 3.5 or MII register 20.13.
It is an input pin during reset period. The default value is
latched at the end of reset.
After reset, it becomes an output pin for testing.
It should be connected to VCC through a 1k ohm resister
to set 1.
Local TP port speed
1: TP port has the 100Mb speed ability
0: TP port has the 10Mb speed ability only
It is valid only if TP_FORCE is enabled.
Local TP port duplex
1: TP port has the Full duplex ability
0: TP port has the Half duplex ability only
It is valid only if TP_FORCE is enabled.
Set the duplex of fiber port
1: full duplex (default)
0: half duplex
defined in SPEED_MODE and DUPLEX_MODE.
half capability (default)
7/22
Description
Preliminary Data Sheet
IP113A LF-DS-R08
IP113A LF
April 9, 2007