1011-267-0605 Deutsch, 1011-267-0605 Datasheet - Page 6

• Manufacturer Part Number: 1011-267-0605
• Description: BACKSHELL, DT, PLUG, 6WAY; Series: DT; Accessory Type: Backshell; For Use With: Deutsch's DT Series; Cable Exit Angle...
• Manufacturer: Deutsch

DT Series Technical Manual
10
SCREW DRIVER INSERTED TO UNLOCK CONTACT
UNLOCKED POSITION
TOOL INSERTED TO UNLOCK CONTACT
UNLOCKED POSITION
LOCKING FINGERS
CONTACT
CONTACT
LOCKING FINGER
Contact Removal Procedure (DTM/DT/DTP)
Contact Insertion System (DTM/DT/DTP)
Contact Retention System (DTHD)
A
Rquired Removal Tool (See page 12)
Contact Insertion Procedure
STEP
CONTACT INSERTION
CONTACT INSERTION
AHEAD
TOOL AND CONTACT REMOVED
CONTACT REMOVED
CONTACT LOCKED POSITION
CONTACT LOCKED IN POSITION
DT Series Technical Manual
1. Grasp crimped contact
approximately 1.0” (25.4mm)
behind the contact barrel.
1. Remove orange wedge using
needlenose pliers to pull wedge
straight out.
Assembly Contact Insertion (DTM, DT, DTP)
A
4. Once all contacts are in place,
insert orange wedge: receptacles
- with half holes aligning with
contacts. Plugs - with contacts
aligning behind full holes. The
orange wedge will snap into
place.
NOTE: The receptacle is shown
- use the same procedure for
plug.
STEP
2. Hold connector with rear
grommet facing you.
2. To remove the contacts,
gently pull wire backwards,
while at the same time releasing
the locking finger by moving it
away from the contact with a
screwdriver.
Contact Removal
AHEAD
3. Hold the rear seal in place,
as removing the contact will
displace the seal.
3. Push contact straight into
connector grommet until a click
is felt. A slight tug will confirm
that it is properly locked in
place.
11