MAX1030BEEG Maxim Integrated, MAX1030BEEG Datasheet - Page 18

• Manufacturer Part Number: MAX1030BEEG
• Description: Analog to Digital Converters - ADC
• Manufacturer: Maxim Integrated

Specifications of MAX1030BEEG

• Number Of Channels: 16/8
• Architecture: SAR
• Conversion Rate: 300 KSPs
• Resolution: 10 bit
• Input Type: Single-Ended/Differential
• Snr: 70 dB
• Interface Type: SPI
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 85 C
• Package / Case: QSOP-24
• Maximum Power Dissipation: 762 mW
• Minimum Operating Temperature: - 40 C
• Number Of Converters: 1
• Voltage Reference: 4.096 V

10-Bit 300ksps ADCs with FIFO,
Temp Sensor, Internal Reference
In clock mode 10, the wake-up, acquisition, conversion,
and shutdown sequences are initiated by writing an
input data byte to the conversion register, and are per-
formed automatically using the internal oscillator. This
is the default clock mode upon power-up. See Figure 6
for clock mode 10 timing.
Figure 5. Clock Mode 01
18
Figure 6. Clock Mode 10
CNVST
SCLK
DOUT
EOC
DIN
SCLK
DOUT
EOC
CS
CS
______________________________________________________________________________________
(ACQUISITION1)
Conversions Using the Serial Interface
THE CONVERSION BYTE BEGINS THE ACQUISITION. CNVST IS NOT REQUIRED. X = DON'T CARE.
REQUEST MULTIPLE CONVERSIONS BY SETTING CNVST LOW FOR EACH CONVERSION. X = DON'T CARE.
(CONVERSION1)
Performing Conversions in Clock Mode 10
Internally Timed Acquisitions and
(ACQUISITION2)
(CONVERSION BYTE)
(CONVERSION2)
(UP TO 514 INTERNALLY CLOCKED ACQUISITIONS AND CONVERSIONS)
MSB1
MSB1
Initiate a scan by writing a byte to the conversion regis-
ter. The MAX1026/MAX1028/MAX1030 then power up,
scan all requested channels, store the results in the
FIFO, and shut down. After the scan is complete, EOC
is pulled low and the results are available in the FIFO. If
a temperature measurement is requested, the tempera-
ture result precedes all other FIFO results. EOC stays
low until CS is pulled low again.
LSB1
LSB1
MSB2
MSB2