S29GL256P90TFCR23 Spansion, S29GL256P90TFCR23 Datasheet - Page 23

• Manufacturer Part Number: S29GL256P90TFCR23
• Description: Flash 256Mb 3V 90ns Parallel NOR Flash
• Manufacturer: Spansion

Specifications of S29GL256P90TFCR23

• Rohs: yes

October 22, 2012 S29GL-P_00_A14
Software Functions and Sample Code
Note
1. Any offset within the device works.
2. base = base address.
The following is a C source code example of using the autoselect function to read the manufacturer ID. Refer
to the Spansion Low Level Driver User’s Guide (available on www.spansion.com) for general information on
Spansion Flash memory software development guidelines.
/* Here is an example of Autoselect mode (getting manufacturer ID) */
/* Define UINT16 example: typedef unsigned short UINT16; */
UINT16 manuf_id;
/* Auto Select Entry */
*( (UINT16 *)base_addr + 0x555 ) = 0x00AA; /* write unlock cycle 1 */
*( (UINT16 *)base_addr + 0x2AA ) = 0x0055; /* write unlock cycle 2 */
*( (UINT16 *)base_addr + 0x555 ) = 0x0090; /* write autoselect command */
/* multiple reads can be performed after entry */
manuf_id = *( (UINT16 *)base_addr + 0x000 ); /* read manuf. id */
/*
*( (UINT16 *)base_addr + 0x000 ) = 0x00F0; /* exit autoselect (write reset command) */
Autoselect Exit Command
Autoselect Command
Autoselect exit */
Unlock Cycle 1
Unlock Cycle 2
Cycle
Cycle
D a t a
S29GL-P MirrorBit
Operation
Operation
S h e e t
Table 7.4 Autoselect Entry in System
Write
Write
Write
Write
(LLD Function = lld_AutoselectEntryCmd)
(LLD Function = lld_AutoselectExitCmd)
Table 7.5 Autoselect Exit
®
Byte Address
Byte Address
Base + AAAh
Base + AAAh
base + XXXh
Base + 555h
Flash Family
Word Address
Word Address
Base + 2AAh
base + XXXh
Base + 555h
Base + 555h
0x00AAh
0x0055h
0x0090h
0x00F0h
Data
Data
23