EA EVALeDIP240J ELECTRONIC ASSEMBLY, EA EVALeDIP240J Datasheet - Page 7

• Manufacturer Part Number: EA EVALeDIP240J
• Description: Display Development Tools Starter/Demoboard w/Touch USB prog
• Manufacturer: ELECTRONIC ASSEMBLY

Specifications of EA EVALeDIP240J

• Product Category: Display Development Tools
• Rohs: yes

ELECTRONIC ASSEMBLY reserves
the right to change specifications
without prior notice. Printing and
typographical
FUNCTION OF PUSHBUTTONS
- “Resetbutton“: As long as you push this
- “Input 1-8“:
USB-INTERFACE
The Evaluation board is connected to a free USB-port of your PC using the supplied USB-cable. The
USB-Interface is located at the upper left corner of the Evalation
board.
Directly to the right there is the a jumper “Select Power“. If you
want to use power over USB you have to set the jumper to the
left.
If you connect the USB-cable, the LED “USB-Power“ (green) is
on. If the jumper is set to power over USB and the driver for
Windows is installed correctly the LED “VDD Power“ is also
glowing; i.e. the whole board is supplied with 5V.
The scope of delivery includes a CD on which you can find the
drivers for the board under “d:\Driver\. These drivers are
designed for Windows 2000, XP, Vista, 7. To install the drivers please follow the instructions of your
operating system.
button the EA eDIP is in Reset mode
(RESET to GND). After release of button
PowerOnMacro is run.
These 8 buttons are directly connected to
the inputs of the EA eDIP. If you push a
button the corresponding input is grounded. Please refer to the schematic on the last page of this
datasheet.
errors
reserved.
EA 9777-2
Page 7