EA EVALeDIP240J ELECTRONIC ASSEMBLY, EA EVALeDIP240J Datasheet - Page 8

• Manufacturer Part Number: EA EVALeDIP240J
• Description: Display Development Tools Starter/Demoboard w/Touch USB prog
• Manufacturer: ELECTRONIC ASSEMBLY

Specifications of EA EVALeDIP240J

• Product Category: Display Development Tools
• Rohs: yes

EA 9777-2
Page 8
POWER SUPPLY
External power supply (e.g. 3.3V):
If you want to run the display with an external supply, you have to set the jumper to the right as you can
see on the picture above on the right.
Please take note of the supply ranges of your eDIP.
Internal power supply:
If you want to run the display with the power of USB-Interface, you have to change the position of the
jumper to the left.
PIN CONNECTORS OF THE BOARD IN CONNECTION WITH INTERFACE EXPANTION
The pin coennectory, you can see on the board EA 9777-2USB provide the repective interfaces.
Attention:
The following description of pin connectors are only operable if the optional
available adapter board EA9777-2PE is mounted.
PORT EXPANSION EA 9777-2PE (included in EA EVALxxx)
Supply by USB
The optional adapter board EA 9777-2PE
expands the Evaluation board with important
interfaces:
“real“ RS232, RS232 CMOS, RS485, SPI and
I²C.
The board consists of 5 individual adapter
boards, which have to be carefully broken
asunder the perforation.
Each adapter board has two LEDs two indicate
data transfer. In addition there is a DIP-Switch.
The adapters intermit the USB connection
between Evaluation board and PC and
configures the eDIP for the desired interface.
Please make sure to reset the display every time
you change the interfaces.
To reuse the USB connection again, you have
to removethe adapter board and reset the
display.
External supply
ELECTRONIC ASSEMBLY reserves
the right to change specifications
without prior notice. Printing and
typographical
errors
reserved.