MD4832-D512-V3Q18-X/Y SanDisk, MD4832-D512-V3Q18-X/Y Datasheet - Page 20

• Manufacturer Part Number: MD4832-D512-V3Q18-X/Y
• Description: IC MDOC G3 512MB 85-FBGA
• Manufacturer: SanDisk

Specifications of MD4832-D512-V3Q18-X/Y

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 512M (64M x 8)
• Speed: 55ns
• Interface: Parallel
• Voltage - Supply: 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 585-1140

2.3.3
9x12 FBGA Package
17
A[12:11]
A[10:8]
A[7:4]
A[3:0]
D[15:14]
D[13:12]
D[11:8]
D[7:6]
D[5:3]
D[2:0]
CE#
OE#
WE#
ID[1:0]
LOCK#
IF_CFG
BUSY#
RSTIN#
CLK
DMARQ#
Table 3: Signal Descriptions for Standard Interface (Mobile DiskOnChip G3 1Gb 9x12 FBGA Package)
Signal
Signal Description
C3, D3, E3, F3
D2, E2, F2, G2
K5, J4, H4, K3
K7, H6, H5
F7, E7, C7
K4, G4, J3
Ball No.
D8, C8
H8, K8
G9, F8
H7, J7
J8, G7
H2
H3
C6
E8
D5
K6
G8
F4
E5
ST, R8 Data bus, high byte. Not used and may be left
Input
Type
OD
OD
ST
ST
ST
ST
ST
ST
ST
ST
ST
ST
Preliminary Data Sheet, Rev. 1.1
Chip Enable, active low.
Address bus. A0 is multiplexed with the DPD ball.
floating when IF_CFG is set to 0 (8-bit mode).
Data bus, low byte.
Write Enable, active low.
Output Enable, active low.
Identification. Configuration control to support up to
two chips cascaded in the same memory window.
Chip 1 = ID1, ID0 = VSS, VSS (0,0); must be used
Chip 2 = ID1, ID0 = VCCQ, VCCQ (1,1)
Lock, active low. When active, provides full
hardware data protection of selected partitions.
Interface Configuration, 1 (VCCQ) for 16-bit
interface mode, 0 (VSS) for 8-bit interface mode.
Busy, active low, open drain. Indicates that
DiskOnChip is initializing and should not be
accessed. A 10 KΩ pull-up resistor is required if
this ball drives an input. A 10 KΩ pull-up resistor is
recommended even if this ball is not used.
Reset, active low.
System Clock.
DMA Request, active low. A 10 KΩ pull-up resistor
is required if this ball drives an input. A 10 KΩ pull-
up resistor is recommended even if this ball is not
used.
System Interface
Configuration
Control
Description
for single chip configuration
Mobile DiskOnChip G3
91-SR-011-05-8L
Signal
Output
Output
Output
Output
Input/
Input/
Type
Input
Input
Input
Input
Input
Input
Input
Input
Input