NCP1606BDR2G ON Semiconductor, NCP1606BDR2G Datasheet - Page 12

• Manufacturer Part Number: NCP1606BDR2G
• Description: IC POWER FACTOR CONTROLLER 8SOIC
• Manufacturer: ON Semiconductor

Specifications of NCP1606BDR2G

• Mode: Critical Conduction (CRM)
• Current - Startup: 20µA
• Voltage - Supply: 10.3 V ~ 20 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Output Voltage Range: 0.5 V
• Output Current: 10 uA
• Power Dissipation: 800 mW
• Operating Temperature Range: - 40 C to + 125 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency - Switching: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: NCP1606BDR2GOSTR

the average demand only. Therefore, the output capacitor
must “absorb” the difference between the delivered power
and the power consumed by the load. This means that when
the power fed to the load is lower than the demand, the
output capacitor discharges to compensate for the lack of
a frequency of either 100 Hz (for 50 Hz mains such as in
Europe) or 120 Hz (for 60 Hz mains in the USA). This
ripple must not be taken into account by the regulation loop
because the error amplifier’s output voltage must be kept
constant over a given ac line cycle for a proper shaping of
the line current. Due to this constraint, the regulation
bandwidth is typically set below 20 Hz. For a simple type 1
compensation network, only a capacitor is placed between
FB and Control (see Figure 1). In this configuration, the
capacitor necessary to attenuate the bulk voltage ripple is
given by:
where G is the attenuation level in dB (commonly 60 dB)
ON TIME SEQUENCE
converter, its switching pattern must accommodate
constant on times and variable off times. The Controller
generates the on time via an external capacitor connected
to pin 3 (Ct). A current source charges this capacitor to a
level determined by the Control pin voltage. Specifically,
Ct is charged to V
(typically 2.1 V). Once this level is exceeded, the drive is
turned off (Figure 27).
As a consequence, the output voltage exhibits a ripple at
Since the NCP1606 is designed to control a CRM boost
C
COMP
CONTROL
+
4 @ p f
Figure 26. Output Voltage Ripple for a Constant Output Power
line
10
P
minus the V
V
IN
20
@ R
OUT
G
OUT1
P
OUT
Vac
Iac
EAL
http://onsemi.com
(eq. 3)
offset
12
power. Alternatively, when the supplied power is higher
than that absorbed by the load, the output capacitor charges
to store the excess energy. The situation is depicted in
Figure 26.
output load, this naturally satisfies equation 1. And if the
values of compensation components are sufficient to filter
Since V
Control
Ct
CONTROL
Figure 27. On Time Generation
V
DD
I
V
CHARGE
varies with the RMS line level and
Ct(off)
DRV
DRV
V
CONTROL
V
V
Ct
CONTROL
t
ON
V
+
EAL
− V
PWM
+
EAL
−
t
ON