IR3720MTRPBF International Rectifier, IR3720MTRPBF Datasheet - Page 14

• Manufacturer Part Number: IR3720MTRPBF
• Description: IC POWER SUPPLY MONITOR 10-DFN
• Manufacturer: International Rectifier
• Series: TruePower™r

Specifications of IR3720MTRPBF

• Package / Case: 10-DFN
• Mounting Type: Surface Mount
• Current - Supply: 480µA
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 125°C
• Applications: Power Supply Monitor
• Voltage - Input: -
• Input Voltage: 3.3V
• No. Of Outputs: 1
• Supply Voltage Range: 3.135V To 3.465V
• No. Of Pins: 10
• Operating Temperature Range: 0°C To +125°C
• Filter Terminals: SMD
• Input Voltage Primary Max: 3.3V
• Rohs Compliant: Yes
• Frequency: 400kHz
• Package: 10 Lead 3x3 DFN
• Vk Range: 0.5V - 1.8V
• Bias Supply Voltage: +3.3V +/-5%
• Junction Temperature: 0oC to 125oC
• Pbf: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Input: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

CONFIGURATION REGISTER
A configuration register is maintained via the I
MFR_SPECIFIC_00 command, code # D0h. The low
order nibble (d3, d2, d1, d0) contains a binary
number N from zero to eight. The averaging interval
is 2
The next bit (d4) is to be used as a function enable
bit. b’1 commands an energy saving shut down
mode, and power on default b’0 commands fully
functioning mode.
d5 high enables the EXTCLK pin to receive the
external clock signal, and default d5 low enables the
internal clock.
The next two bits (d7, d6) program the output
parameter. B’00 causes power to be measured and is
the power on default state. B’01 causes voltage to be
measured. B’10 causes current to be measured. B’11
is not defined and should not be used.
The next bit (d8) is used to configure the ALERT#
pin. b’0 is the power on default, and commands
ALERT# being pulled low when new data is available.
b’1 programs the ALERT# to pull low when the
programmable threshold level is exceeded, whether it
is power, voltage, or current.
Register bits (d15...d9) are the ALERT# threshold
register. If the output register is larger than this
register, and if (d8) is b’1, then the ALERT# pin will
pull low. The two least significant bits of the output
register are not represented in the ALERT# threshold
register. d15…d9 defaults to zero on start up.
Page 14 of 20
N
milliseconds. N defaults to zero on start up.
www.irf.com
2
C
The results of a configuration register change will be
reflected in the OUTPUT REGISTER after previously
requested operations have completed.
BIT #
d0
d1
d2
d3
d4
d5
d6
d7
d8
d9
d10
d11
d12
d13
d14
d15
CONFIGURATION REGISTER
Averaging interval (LSB)
Averaging interval
Averaging interval
Averaging interval (MSB)
Enable
External clock
OUTPUT config (LSB)
OUTPUT config (MSB)
ALERT# configuration
ALERT# threshold (LSB + 2)
ALERT# threshold
ALERT# threshold
ALERT# threshold
ALERT# threshold
ALERT# threshold
ALERT# threshold (MSB)
09/09/08