LT3437IFE#TRPBF Linear Technology, LT3437IFE#TRPBF Datasheet - Page 8

• Manufacturer Part Number: LT3437IFE#TRPBF
• Description: IC REG SW HV 500MA 16-TSSOP
• Manufacturer: Linear Technology
• Type: Step-Down (Buck)r

Specifications of LT3437IFE#TRPBF

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 1.25 ~ 54 V
• Current - Output: 500mA
• Frequency - Switching: 200kHz
• Voltage - Input: 3.3 ~ 60 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP Exposed Pad, 16-eTSSOP, 16-HTSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -

PI FU CTIO S
LT3437
8
SW (Pin 1/Pin 2): The SW pin is the emitter of the on-chip
power NPN switch. This pin is driven up to the input pin
voltage during switch on time. Inductor current drives the
SW pin negative during switch off time. Negative voltage
is clamped with an external schottky catch diode to pre-
vent excessive negative voltages.
NC (Pins 1, 3, 5, 7, 13, 16)(FE Package ONLY):
No Connection. The NC pins are electrically isolated from
the LT3437. The NC pins may be connected to PCB traces
to aid PCB layout.
V
NPN switch. V
a voltage on the BIAS pin is not present. High di/dt edges
occur on this pin during switch turn on and off. Keep the
path short from the V
capacitor, through the catch diode back to SW. All trace
inductance on this path will create a voltage spike at switch
off, adding to the V
BOOST (Pin 3/Pin 6): The BOOST pin is used to provide a
drive voltage, higher than the input voltage, to the internal
bipolar NPN power switch. Without this added voltage, the
typical switch voltage loss would be about 1.5V. The
additional BOOST voltage allows the switch to saturate
IN
U
(Pin 2/Pin 4): This is the collector of the on-chip power
U
IN
powers the internal control circuitry when
CE
U
voltage across the internal NPN.
IN
(DD/FE)
pin through the input bypass
and its voltage loss approximates that of a 0.8Ω FET
structure.
GND (Pins 4, 11/Pins 8, 17): The GND pin connection
acts as the reference for the regulated output, so load
regulation will suffer if the “ground” end of the load is not
at the same voltage as the GND pin of the IC. This
condition will occur when load current or other currents
flow through metal paths between the GND pin and the
load ground. Keep the path between the GND pin and the
load ground short and use a ground plane when possible.
The GND pin also acts as a heat sink and should be
soldered (along with the exposed leadframe) to the cop-
per ground plane to reduce thermal resistance (see Appli-
cations Information).
C
regulated output voltage determines the output voltage
ramp rate during start-up. When the current through the
C
age ramp of the output is limited. The C
proportional to the FB voltage (see Typical Performance
Characteristics) and is defeated for FB voltage greater than
0.9V (typical). See Soft-Start section in Applications Infor-
mation for details.
SS
SS
capacitor exceeds the C
(Pin 5/Pin 9): A capacitor from the C
SS
threshold (I
SS
CSS
SS
threshold is
), the volt-
pin to the
3437fc