MAX1687EUE Maxim Integrated Products, MAX1687EUE Datasheet - Page 6

• Manufacturer Part Number: MAX1687EUE
• Description: IC CONV DCDC GSM LIMIT 16-TSSOP
• Manufacturer: Maxim Integrated Products
• Type: Step-Up (Boost)r

Specifications of MAX1687EUE

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: 1.25 ~ 6 V
• Current - Output: 2.5A
• Frequency - Switching: 1MHz
• Voltage - Input: 2.7 ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Power - Output: 457mW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The MAX1687 and MAX1688 ICs supply power ampli-
fiers in GSM applications where limited input current
surge is desirable. For example, GSM systems require
high-power, 12% duty-cycle RF bursts. Synchronizing
the MAX1687/MAX1688 to enter standby mode during
these RF bursts eliminates battery surge current and
minimizes switching noise to the power amplifier. In
standby mode, the charged output reservoir capacitor
delivers power to the power amplifier. Between each
burst, the DC-DC converter switches on to charge the
output capacitor. To improve efficiency and reduce peak
battery current, the MAX1687/MAX1688 provide a volt-
Step-Up DC-DC Converters with
Precise, Adaptive Current Limit for GSM
6
_______________________________________________________________________________________
SO
—
—
—
—
—
1
2
3
4
5
6
7
8
MAX1687
TSSOP
11, 12
13, 14
15, 16
1, 2
3, 4
10
—
—
5
6
7
8
9
PIN
Detailed Description
SO
—
—
—
—
—
1
2
3
4
5
6
7
8
MAX1688
TSSOP
11, 12
13, 14
15, 16
1, 2
3, 4
10
—
—
5
6
7
8
9
NAME
AGND
PGND
CHG
GND
N.C.
OUT
REF
LX1
LIM
LX2
ON
FB
IN
Supply Voltage Input. Connect Battery to IN. Bypass to GND with
a 47µF minimum capacitor.
Internal Current-Sense Resistor Output. Connect the inductor
between LX1 and LX2.
Voltage-Controlled Current-Limit Adjust Input. Apply a voltage
between 0 and 1V to vary the current limit. LIM is internally
clamped to 1.25V.
Constant-Recharge-Time Input. Set the recharge time of the out-
put reservoir capacitor by connecting a resistor from CHG to GND
(see Applications Information section).
Feedback Input. Connect a resistor-divider from OUT to GND to
set the output voltage. FB regulates to a nominal 1.25V.
Reference Voltage Output. 1.25V nominal.
No Connection. Not internally connected.
Logic ON/OFF Input. When ON is high, the device operates in
normal mode. When ON goes low, the device goes into standby
mode. If ON remains low for greater than 1.2ms, the device shuts
down (see Standby/Shutdown section). The supply current falls to
3µA in shutdown mode.
Ground
Analog Ground
Power Ground
N-Channel and P-Channel MOSFET Drain
Output
age-controlled current limit. The MAX1688 is a MAX1687
with added self-regulating circuitry that recharges the
reservoir capacitor in a fixed time (Figure 1).
In a conventional DC-DC converter, when high current
is required by the load, the battery voltage droops due
to battery series resistance. This may cause other cir-
cuitry that depends on the battery to malfunction or be
reset. The MAX1687/MAX1688 prevent battery voltage
droop by charging the reservoir capacitor during sys-
tem off-time and isolate the battery from the output dur-
ing high current demand. The MAX1687/MAX1688 are
gentle to the battery during initial power-up, as well.
FUNCTION
Pin Description
Start-Up Sequence