MAX1687EUE Maxim Integrated Products, MAX1687EUE Datasheet - Page 8

• Manufacturer Part Number: MAX1687EUE
• Description: IC CONV DCDC GSM LIMIT 16-TSSOP
• Manufacturer: Maxim Integrated Products
• Type: Step-Up (Boost)r

Specifications of MAX1687EUE

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: 1.25 ~ 6 V
• Current - Output: 2.5A
• Frequency - Switching: 1MHz
• Voltage - Input: 2.7 ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Power - Output: 457mW
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Step-Up DC-DC Converters with
Precise, Adaptive Current Limit for GSM
If desired, drive ON low during periods of high current
demand to eliminate switching noise from affecting
sensitive RF circuitry. During the periods when ON is
low, the output reservoir capacitor provides current to
the load (Figure 4).
Although the IC is not intended for this application, the
MAX1687/MAX1688 operate as a buck converter when
the input voltage is higher than the output voltage. The
MAX1687/MAX1688 are not optimally efficient in this
mode (see Typical Operating Characteristics for
efficiencies at 2.7V, 3.3V, 5V, and 6V input supply volt-
ages).
Figure 3. Setting the Output Voltage
8
Figure 2. Hysteretic Inductor Current
( ) ARE FOR MAX1688
_______________________________________________________________________________________
I
PEAK
V
LIM
- 200mA
SET BY
(V
R1 = R2
I
PEAK
CHG
)
MAX1687
MAX1688
(
V
OUT
V
FB
- V
FB
)
TIME
OUT
Synchronized ON Pin
FB
Buck Capability
R1
R2
HYSTERESIS
BAND
V
OUT
Adjust the MAX1687/MAX1688 output voltage with two
external resistors (Figure 3). Choose R2 to be between
10kΩ to 100kΩ. Calculate R1 as follows:
where V
nominal.
The MAX1687 has an adjustable current limit for appli-
cations requiring limited supply current, such as PC
card sockets or applications with variable burst loads.
For single Li-Ion battery cell applications, the high peak
current demands of the RF transmitter power amplifier
can pull the battery very low as the battery impedance
increases toward the end of discharge. The reservoir
capacitor at the output supplies power during load-cur-
rent bursts; this allows for a lower input current limit.
With this feature, the life of the Li-Ion battery versus the
reservoir capacitor size trade-off can be optimized for
each application.
Figure 4. Timing Diagram of “ON”
CONTROL INPUT
FB
Adjusting Current Limit (MAX1687)
I
V
“ON”
LOAD
OUT
is the feedback threshold voltage, 1.25V
R1 = R2 · (V
Applications Information
Adjusting the Output Voltage
OUT
TIME
- V
FB
) / V
FB