LQ038Q5DR01 Sharp Microelectronics, LQ038Q5DR01 Datasheet
LQ038Q5DR01
Specifications of LQ038Q5DR01
Available stocks
Related parts for LQ038Q5DR01
LQ038Q5DR01 Summary of contents
Page 1
... P S RODUCT PECIFICATIONS LQ038Q5DR01 TFT-LCD Module Spec. Issue Date: August 4, 2005 AVC Liquid Crystal Displays Group No: LCY-00044D ...
Page 2
...
Page 3
... KX15-40K*D1 to KX15-40K*D-VI,KX15-40 K*D1 or KX15-40KLDL. Adapted RoHs direction Adapted lead free PWB & Lamp Indicatin of lot number label LQ038Q5DR01 T → LQ038Q5DR01 A to modify the name of used connector from KX14-40K5D-VI to KX14-40K5D-VIE. Adapted RoHs direction Carton size 483(W)×166(H)×314(D)mm → ...
Page 4
This publication is the proprietary of SHARP and is copyrighted, with all rights reserved. Under the copyright laws, no part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical for any ...
Page 5
... This specification literature applies to color TFT-LCD module , LQ038Q5DR01. (2)Summary and Features ・This module is a color active matrix LCD module incorporating amorphous silicon TFT ( Thin Film Transistor ). ・It is composed of a color TFT-LCD panel, driver ICs, control-PWB, FPC, frame, front shielding case, back-light unit. ・ ...
Page 6
Used connector :KX14-40K5D-VIE(JAE Co. , Ltd) Fit connector :KX15-40K*D-VI , KX15-40K*D1 or KX15-40KLDL (JAE Co. , Ltd) (lock type) :*:2,3,・・・ Table 4-1 CN1【Note4-4】 Pin No. Symbol ground 1 GND Power supply voltage 2 VCC ...
Page 7
Hsync positive Vsync positive 【Note 4-2】 The horizontal display start timing is settled in accordance with a rising timing of ENAB signal. In case ENAB is fixed “Low”, the horizontal start timing is determined as described in Fig3-A. ...
Page 8
Table 6-1 Parameter +3.3V Supply voltage Current dissipation Permissive input ripple Input Low voltage Input High voltage Input current (Low) Input current (High) Input current (Low) Input current (High) Input current (Low) Input current ...
Page 9
The backlight system is an edge-lighting type with single CCFT (Cold Cathode Fluorescent Tube). The characteristics of Lamp are shown in the following table. Table 6-2 Parameter Symbol lamp ...
Page 10
ENAB is active The horizontal display position is determined by ENAB signal and the input data corresponding to the rising edge of ENAB signal is displayed at the left end of the active area. (shown ...
Page 11
Signals, Basic Display Color and Gray Scale of Each Color Colors & Gray scale R0 R1 Gray Scale Black 0 0 − Blue 0 0 − Green 0 0 − Cyan 0 0 − Red 1 1 − Magenta ...
Page 12
Table 9-1 Parameter Symbol Viewing angle △θ11 range △θ12 △θ2 Contrast ratio CRmax Response Rise τr time Fall τd Luminance Y White chromaticity x y lamp life +25℃ - time -30℃ - DC/AC inverter for external connection shown ...
Page 13
Viewing angle range is defined as follows. θ 2 θ o’clock direction 【Note 9-2】 Contrast ratio is defined as follows: Contrast ratio(CR)= 【Note 9-3】 Response time is obtained by measuring the transition time of photo detector ...
Page 14
Measured on the center area of the panel at a viewing cone 2°(= Filed) by TOPCON luminance meter BM-5A or ELDIM luminance meter EZ Contrast. (After 30 minutes operation) DC/AC inverter driving frequency:( 49 kHz) 【Note 9-5】 Measured ...
Page 15
Do not exist extreme defects. (See Fig. 1) 10-2)Panel toughness The panel shall not be broken ,when 19N is pressed on the center of the panel by a smooth sphere having 15 mm diameter. Caution: In ...
Page 16
Polarizer which is made of soft material and susceptible to flaw must be handled carefully. Protective film (Laminator) is applied on the surface to protect it against scratches and dirties recommended to peel off the ...
Page 17
Adjusting volumes on the rear face of the module have been set optimally before shipment. Therefore, do not change any adjusted values. If adjusted values are changed, the specifications described here may not be satisfied. 12-4)Caution ...
Page 18
... Please be careful since image retention may occur when a fixed pattern is displayed for a long time. 15-1)Indication of lot number ①Attached location of the label ②Indicated contents of the LQ038Q5DR01 A ○○○○○○○○ contents of lot No. : See Fig. 1 model No. lot No. ...
Page 19
Reliability Test Conditions for TFT-LCD Module Remark) Temperature condition is based on operating temperature conditions on (5)-Table 5-1. No. Test items High temperature storage test 1 Low temperature storage test 2 High temperature and high humidity 3 operating test High ...
Page 20
LCY00044−17 ...
Page 21
Fig.2. Structure of the module LCY00044−18 ...
Page 22
THp Horizontal sync. signal (Hsync) THc Clock signal (CK Data ...
Page 23
THp Horizontal sync. signal (Hsync) THc Clock signal (CK ...
Page 24
Fig.4.Packing form Fig.4.Packing form LCY00044-21 LCY00044-21 ...
Page 25
This publication is the proprietary of SHARP and is copyrighted, with all rights reserved. Under the copyright laws, no part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical for any ...
Page 26
... ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR USE AND FITNESS FOR A PARTICULAR PURPOSE, ARE SPECIFICALLY EXCLUDED event will SHARP be liable any way responsible, for any incidental or consequential economic or property damage. NORTH AMERICA SHARP Microelectronics of the Americas 5700 NW Pacific Rim Blvd. Camas, WA 98607, U.S.A. Phone: (1) 360-834-2500 ...