PV37P502A01B00 Murata Electronics North America, PV37P502A01B00 Datasheet - Page 19

• Manufacturer Part Number: PV37P502A01B00
• Description: POT 5K OHM TRIM CERM 12TRN SIDE
• Manufacturer: Murata Electronics North America
• Series: PV37r

Specifications of PV37P502A01B00

• Resistance (ohms): 5K
• Power (watts): 0.25W, 1/4W
• Taper: Linear
• Tolerance: ±10%
• Temperature Coefficient: ±150ppm/°C
• Number Of Turns: 12
• Adjustment Type: Side Adjustment
• Mounting Type: Through Hole
• Resistive Material: Cermet
• Package / Case: Square - 0.264" L x 0.252" W x 0.157" H (6.70mm x 6.40mm x 4.00mm)
• Resistance In Ohms: 5.00K
• Lead Free Status / RoHS Status: Lead free / RoHS non-compliant
• Other names: 490-2365

8
!Note
!Note
1. Use suitable screwdrivers that fit comfortably in
2. Don't apply more than 9.8N (Ref.; 1kgf) of twist
1. Please make sure that your product has been
2. Murata cannot guarantee trimmer potentiometer
72
PV12/PV37/PV23/PV22/PV36 Series Notice
Notice (Handling)
driver slot. We recommend the screwdrivers below.
* Recommended screwdriver for manual adjustment
We can supply the screwdrivers above.
If you place order, please specify the Murata P/N.
and stress after mounting onto PCB to prevent
contact intermittence. If excessive force is
Notice (Other)
evaluated and confirmed against your
specifications when our product is mounted to your
product.
integrity when used under conditions other than
those specified in this document.
ENGINEER INC. : DA-40
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specifications before ordering.
(Murata P/N : KMDR180)
3. When adjusting with an adjustment tool, the applied
4. When using a lock paint to fix slot position,
applied, the trimmer potentiometer may not
function.
force to the adjustment screw should not exceed
4.9N (Ref.; 500gf). If excessive force is applied,
the trimmer potentiometer may not function due to
damage.
please use adhesive resin without chlorine or
sulfur (Three-bond "1401 series").
R50E13.pdf 04.6.11