AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 3

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
AE-ISP-U1 connection for the SST SST26xx
AE-ISP-U1 connection for the STMicroelectronics M35080
AE-ISP-U1 connection for the STMicroelectronics M45Pxxx devices
AE-ISP-U1 connection for the STMicroelectronics STM32 devices in the BootLoader (BL) Mode
AE-ISP-U1 connection for the TI MSP430 devices in the BSL Mode with the TEST pin
AE-ISP-U1 connection for the TI MSP430F13x/14x devices in the BSL Mode
AE-ISP-U1 connection for the TI MSP430F4xx devices in the BSL Mode
AE-ISP-U1 connection for the Zilog Z8F devices
AE-ISP-U1 connection for the 24xx devices
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
programmed chip from rest of target system. Recommended value of resistors R1..R6 is 2k or more.
You can also use jumpers instead of the resistors.
ISP characteristics:
1. Programmer's output capability:
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
ChipProg+
ChipProg-40
ChipProg-48, ChipProg-G4
Powering the target device:
There are two alternative options for powering
the targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the
target power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or
external power supply. In this case the power
output from the programmer should not be
connected with the target. The target system
should be tolerant to applying logical signals
with the voltage levels exceeding the voltages on
the target.
NOTE! It is strictly prohibited to power the
target from both the programmer and built-in or
external power supply simultaneously.
Isolating resistors:
Purpose of the R1..R6 resistors is to isolate the
Page 3 of 56
8/19/2010