STEVAL-IPE009V1 STMicroelectronics, STEVAL-IPE009V1 Datasheet - Page 37

• Manufacturer Part Number: STEVAL-IPE009V1
• Description: BOARD EVAL ST72321BR9/STPM14
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-IPE009V1

• Main Purpose: Power Management, Energy/Power Meter
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STPM14, ST72F321BR9T6
• Primary Attributes: 1-Ph 220 VAC, LCD Displays: No-Load, Reverse, Fraud, or Case Tampering
• Secondary Attributes: Up to 4 Tariff Rates, Data Accumulated for Meter Life, Time Stamp for: Tamper, Fraud, Power Failure
• Input Voltage: 220 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Silicon Core Number: ST72321BR9 And STPM14
• Features: Continuously Detects, Displays No-Load Condition, Reverse Direction, Fraud And Case Tamper Condition
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STPM14, ST72321BR9
• Other names: 497-8434; STEVAL-IPE009V1

STPM11, STPM12, STPM13, STPM14
9
Table 17.
Table 18.
Symbol
Symbol
Cv, Ci
Av, Ai
Vbg
Gp
Vn
DL
fM
In
Si
P
Line RMS current
Line RMS voltage
Power sensitivity
Shunt Sensor
Reference voltage
Clock
Amplification of ADC
Gain of voltage and current decimation filters
Calibration data range
AW Bit position that generates LED signal
STPM1x calibration
Energy meters based on STPM1x devices are calibrated on the frequency of the output
pulse signal.
The devices are comprised of two independent meter channels for line voltage and current
respectively. Each channel includes its own digital calibrator, to adjust the voltage and
current signals coming from the sensors in the range of ±12.5% in 256 steps. A digital filter
is included to remove any signal DC component.
The devices produce an energy output pulse signal whose frequency is proportional to the
measured active energy.
The devices have an embedded memory, 54 bits, used for configuration and calibration
purposes. The value of these bits can be written temporarily or permanently through CFGI
communication channel.
The basic information needed to start the calibration procedure is found in
Table
Calibration entries
The following typical STPM01 parameters and constants are also known:
Device calculation constants
Av is constant. While, Ai is chosen according to the sensor
Gv and Gi are constant
Cv and Ci are 8bits register (CHV, CHP and CHS)
From the values above and for both the given amplification factor and initial calibration data,
the following target values can be calculated:
Considering that Ci=0 generates a correction of 75% and that Ci=128 determines a
correction factor of 87.5%, and the same for Cv, the total correction for the power stands
Description
18:
Description
(230 V)
(5 A)
(LED: P=128000 pulses/kWh, Stepper Motor: PM=P/64= 2000 pulses/kWh)
0,42 mV/A
Doc ID 13167 Rev 7
Value
(1.23 V ± 2%)
(2
[4 ± 1%, (8, 16, 24, 32) ± 2%)]
(0.504008)
(min = 0, ini = 128, max = 255)
(2
23
11
)
Hz ± 50ppm)
Value
STPM1x calibration
Table 17
and
37/46